Dir Sir. I am checking the current profile of nRF24AP2 in RX mode.
After "open channel" command, I found the peak current at 10ms interval until connection pass.
How does...
Hello,
I am using Nordic's UART service to communicate with my project. I use iOS and also Master Control Panel (with a dongle) on a laptop.
I have two questions:
...
SWI*_IRQ is using by softdevice to send event to application, I want to know which priority does softdevice set for them?
Does sd_nvic_critical_region_enter() disable...
I am a started guy.
I only need a bluetooth device (BLE) to check the signal and mac address.
What is the best choice?
I need the smallest and low powered!
Thank you...
I am working on code to setup a bond manager for ancs based off of the example, but have a fixed advertising and connection interval of 25ms. How does the bond manager and...
Hello,
We have experienced odd problem, we are not able to scroll up or down SDK documentation at these pages on Android devices. IPHONE browser Safari works ok. Any help...
In our product we have implemented buttonless DFU over BLE with the secure boot-loader (unbonded) on SDK 15.2. The bootloader is unmodified except for the addition of PA/LNA...
When I compile the program times an error :
.\_build\nrf52810_xxaa_s112.axf: Error: L6366E: uECC.c.o attributes are not compatible with the provided attributes . Object...
I am trying to run the SPI code on an NRF52382 based custom board. I am using the NRF 52 DK, Keil uVision 5.0 , SDK 15.2.
I cannot set and clear the SPI relevant pins...
I am evaluating the nRF52840 for developing wearable tech that would implement some basic sensors such as GPS & pedometer. Just have a couple questions regarding the transition...
Hi all,
I am sorry if this is a rookie question. I had researched and tried the methods shown online, including:
added $(ProjectDir)/flash_placement.xml to the linker...
Hi
I am working on nrf52840, try to create a service,so i follow the tutorial , but i got a problem. The DK doesn't advertise, when I debug it, then it will jump into this...
Hi,
I manged to successfully run the mesh DFU example, however i noticed one unusual thing. I was expecting device to revert to old version of firmware, if in case the...
Is there an example somewhere to show how to use the "BLE_APPEARANCE_GENERIC_HID" to transfer data over BLE to a another BT device such as a laptop ?
The HID mouse and HID...
Hi,
I have a use in mind for a Nordic part, probably the nRF52810. It would be nice to have an input on one pin act as an output enable for several other pins, i.e. when...
Getting "Failed to read PPK metadata" issue on measuring current of external device with external supply. I use nRF6707 PPK booth with PCA10028 or PCA10040 (doesn't work in...
Hi All.
Currently we are using buttonless-dfu service to upgrade firmware via ble on an nrf peripheral-device (via nrf-connect app on mobile central-device). Next, in order...
I am trying to implement the central side code for the usbd_ble_uart example. My current target is the nRF52840 Development Kit but the final target is the nRF52840-Dongle...
Hello!
I am developing a solution that has a gateway and about 10 devices.
The devices has some sensors and their are connected in gateway. Actually I catch the sensor...
Hi:
I am having a problem with the fstorage and ble_stack_init. When fstorage is used before the ble_stack_init it works fine. If used after ble_stack_init, the fstorage...
