Hello：
Why Bluetooth Go to system-off mode, sd_power_ramon_set can not be stored. In D: \ RAM save nrf51_sdk_v5_2_0_39364 \ nrf51822 \ Board \ nrf6310 \ s110 \ ble_app_rscs...
Hi,
Recently I want to set up a dynamic network that with the node change this position ,the network will change dynamically.But there is the question,with the node's position...
Dir Sir. I am checking the current profile of nRF24AP2 in RX mode.
After "open channel" command, I found the peak current at 10ms interval until connection pass.
How does...
Hello,
I am using Nordic's UART service to communicate with my project. I use iOS and also Master Control Panel (with a dongle) on a laptop.
I have two questions:
...
SWI*_IRQ is using by softdevice to send event to application, I want to know which priority does softdevice set for them?
Does sd_nvic_critical_region_enter() disable...
I am a started guy.
I only need a bluetooth device (BLE) to check the signal and mac address.
What is the best choice?
I need the smallest and low powered!
Thank you...
I realize this product (Primo) has been “retired”, but am wanting to know how safe it is to use for home automation.
i don’t want any blames assigned, just would like to...
Hi !
I want to build a distance measure hardware by myself and for this i need to make some i/o pulses (about 7-8) very accurate in 40Khz. after that, i need to implement...
Hi Folks,
I found that the interactive pyaci is setting wrong parameters if I try to set the heartbeat publication.
What I did:
Python:
cc.heartbeat_publication_set...
Hi,
I would like to use the Device Information Service and to be able to write the HW revision string from the central device (in my case the nRF Connect app). Per default...
I am working on nRF52832 controller for a small project . I am completely new to this series of controller.
I want to develope a firmware to measure Humidity and Temperature...
I am developing one project where I use the Rigado BMD-300 Series Evaluation Kit for controlling one ws2812b strip with 8 LED.
Currently, the system work as I intend when...
We are developing our product on nRf52832QFAAB0 SoC. BLE 4.2 is currently implemented in our products.
Seeing all features in BLE5 (long range, Higher throughput, increase...
Hi,
Why doesn't Nordic offer a stand-alone BLE controller variant of its softdevice protocol stack? As far as I understand, the softdevices includes both Host and Controller...
hi,
I am using nRF52-DK with nrf Sniffer
What are LED 1 and LED 2 Indicate ?
Initially LED 2 Blinks very Fast, Sometimes LED 1 is Off LED 2 is ON
sometimes LED 1 and...
When and where can we purchase the nRF52840 chip for engineering developpement and production in China, and how long is Manufacturer Lead Time? Thank you.
I am using nRF Connect app testing bluetooth connection ,and I got problems in some Moto phones ,and error message is in the below pictures , below model number is Moto Z...
Hello,
I'm currently migrating from SDK13.1 to 15.0. I'm doing it in steps so I first started migrating to SDK14.2. After I finally got rid of all the warnings and errors...
I am using nRF52832 pca10040 developement board. As I am begineer I dont know much about coding. I am using Eclipse IDE for developement. I want to transmit 1-10 numbers using...
BLE_GAP_ADV_SET_DATA_SIZE_MAX is use din ble_advertising.h
This macro is defined in ble_gap.h for each softdevice - however not in the header for S332. Also ble_gap_adv_data_t...
