Hi,
Recently I want to set up a dynamic network that with the node change this position ,the network will change dynamically.But there is the question,with the node's position...
Dir Sir. I am checking the current profile of nRF24AP2 in RX mode.
After "open channel" command, I found the peak current at 10ms interval until connection pass.
How does...
Hello,
I am using Nordic's UART service to communicate with my project. I use iOS and also Master Control Panel (with a dongle) on a laptop.
I have two questions:
...
SWI*_IRQ is using by softdevice to send event to application, I want to know which priority does softdevice set for them?
Does sd_nvic_critical_region_enter() disable...
I am a started guy.
I only need a bluetooth device (BLE) to check the signal and mac address.
What is the best choice?
I need the smallest and low powered!
Thank you...
I am working on code to setup a bond manager for ancs based off of the example, but have a fixed advertising and connection interval of 25ms. How does the bond manager and...
Hi everyone,
I tried to test nRF51-ble-app-uart-static-passkey to learn the static passkey method.
I used PCA10001 EK board, with S110_7.1.0 and SDK_6.1.0.
Well, if I connect...
The maximum data length of a characteristic is 9, and I use the follow function to send the notification to a client
uint32_t dxs_send(dr_ble_dxs_t * p_dxs, uint8_t * p_data...
Hello,
I am debugging through UART with nrf52 and s132 softdevice using Keil V5 for the proximity app. When I flash the example app from the 9.2 SDK and look at the debug...
Is there a migration guide for the SDK 10 somewhere? I think the use of the APP_TIMER_DEF() macro is one thing that should be in it. Took me a while to understand why the...
Hello There,
As mentioned in the S132 specification (S132_SDS_v0.5.pdf), when acted as a peripheral and the connection time interval is 7.5ms, for the case of a GATT server...
I am running Windows 7 Pro SP 1 64 bit and have gong through the tools installation procedure, in particular running nRFTools_7_7_0_Installer.exe. This ran the J-Link V5.02...
When building a solution that supports Bluetooth MAC address randomization are there any options available in nRF Sniffer to allow packets to be captured. e.g. potentially...
Hello,
I do connections between nRF51 in my application.
When the central detect an advertising frame, it ask to a server is the device is allowed (few ms). When server...
I am very familiar with the arduino side but the BLE is brand new to me. I was wondering if I can use P0.00 and P0.01 to talk to the arduino and if its possible how exactly...
Hi,
As explained in devzone.nordicsemi.com/.../ I want to interface my Beacon to a Invensense sensor with I2C. I'm having a hard time about using the I2C drivers/examples...
i failed to program the ptr5518 module with a jlink EDU.
it gives me :
$ JLinkExe
SEGGER J-Link Commander V5.02 ('?' for help)
Compiled Aug 28 2015 19:48:33
DLL...
I'm following the SDK 8.1 example from here with S210 v4 but I never seem to get a PSTORAGE_STORE_OP_CODE or PSTORAGE_UPDATE_OP_CODE.
I do however get the PSTORAGE_LOAD_OP_CODE...
