Dir Sir. I am checking the current profile of nRF24AP2 in RX mode.
After "open channel" command, I found the peak current at 10ms interval until connection pass.
How does...
Hello,
I am using Nordic's UART service to communicate with my project. I use iOS and also Master Control Panel (with a dongle) on a laptop.
I have two questions:
...
SWI*_IRQ is using by softdevice to send event to application, I want to know which priority does softdevice set for them?
Does sd_nvic_critical_region_enter() disable...
I am a started guy.
I only need a bluetooth device (BLE) to check the signal and mac address.
What is the best choice?
I need the smallest and low powered!
Thank you...
I am working on code to setup a bond manager for ancs based off of the example, but have a fixed advertising and connection interval of 25ms. How does the bond manager and...
Hello,
We have experienced odd problem, we are not able to scroll up or down SDK documentation at these pages on Android devices. IPHONE browser Safari works ok. Any help...
I am currently working on a design with the nRF9160, and have a few questions about the DEC0 pin and decoupling for the module in general. I have been considering adding additional...
Hello,
I am use bonding and want to forbid new bonding if proprietary authentication criteria is not met.
For example, I want to allow bonding only if my device is on...
Hi, I am using nRF5_SDK_15.0.0_a53641a.
I'm using code below to start WD and I'm not feeding WD.
After WD reset, I'm looking at RESETREAS register and DOG bit is...
Hi,
we are currently in the process of optimizing our connections for better throughput. Use-case is connection based FruityMesh ( https://github.com/mwaylabs/fruitymesh...
Sir i am using only one nrf52840 board
Sir i am changing router role to coordinator role and also remove the zb_ed_role in preprocessor definition
now the project building...
-> The Command zdo match_desc 0xfffd 0xfffd 0xc05e 1 0 0 is Entered in the teraterm this function taking the input from those command by using argc and argv
-> our plan...
Hi,
I have some question, If I use BLE protocol.
From nRF52811 Product Spcification as link https://infocenter.nordicsemi.com/index.jsp?topic=%2Fps_nrf52811%2Fkeyfeatures_html5...
I would like to set the tx power for all roles such that the nRF52840 (s140) never transmits anything above my specified level. This includes advertisements, past connections...
OS in development environment :Windows7 HARD :(Taiyo Yuden)EBSHSN Series Evaluation Board : Central / Peripherals CPU :(Nordic) nRF52832 / ARMR Cortex-M4F 32 bit processor...
Hi,
I think you have deadlock situation or wrongly used interface in driver at_cmd.
The master branch is using functionality using function at_cmd_set_notification_handler...
Versions:
Segger Embedded Studio v418,
nRF SDK v1.0.0 tag
For the NB-IoT network I wish to connect to, I need to specify the APN, I can see through "Configure nRF Connect...
nRF52832 doesn't seem to wake up when an event is generated. I confirmed that the RTC0 is active and the event is generated
upon COMPARE[0] match using the SES debugger...
Since GPS can only function during the PSM window and the network can ignore the nRF9160's request for PSM mode, I need a solution that works with and without PSM mode. This...
Hello,
I need help. I cannot see my earlier ongoing ticket!? I have been working With it for the last couple of Days and today i was asked to share my Project but now the...