Hi,
Recently I want to set up a dynamic network that with the node change this position ,the network will change dynamically.But there is the question,with the node's position...
Dir Sir. I am checking the current profile of nRF24AP2 in RX mode.
After "open channel" command, I found the peak current at 10ms interval until connection pass.
How does...
Hello,
I am using Nordic's UART service to communicate with my project. I use iOS and also Master Control Panel (with a dongle) on a laptop.
I have two questions:
...
SWI*_IRQ is using by softdevice to send event to application, I want to know which priority does softdevice set for them?
Does sd_nvic_critical_region_enter() disable...
I am a started guy.
I only need a bluetooth device (BLE) to check the signal and mac address.
What is the best choice?
I need the smallest and low powered!
Thank you...
I am working on code to setup a bond manager for ancs based off of the example, but have a fixed advertising and connection interval of 25ms. How does the bond manager and...
Hello,
I'm wondering that it is ok to route ANT line through board-to-board connector to chip antenna.
Because there is no space to place nRF52832 and chip antenna together...
Hi,
I've seen that SDK 12.3.0 contains a new version of the application sample using the Eddystone protocol for BLE. I would like to know if this version is compatible...
I am using the template example for S130(works fine).
I tried adding a simple Pin interrupt on the code but it didn't call the pin interrupt handler everytime I press the...
For applications using the application UART Module ) via APP_UART_FIFO_INIT() without hardware flow control - how does an application put the UART peripheral to sleep?
...
Hello Nordic staff (or anyone in the know),
I saw this post from @newtom almost a year ago which concluded that I2S master library does not support 32bit words from mics...
Hello there,
I am a beginner, i want to know what changes should i make in the already existing example "ble_app_uart" so as to make my nrf51 development kit able to transfer...
In the file app_sdcard.c of the SDK13.0.0, an assert is done when calling app_sdc_init() with a pin P0.0. Can i safely use P0.0 with the assert deactivated or should i use...
Hi;
I am using nrf51822 qfaa device with sdk12.3. I compiled eddystone example code and it worked with nrf51dk(nrf51422_qfac) board. Also, i have a board that has nrf51822_qfaa...
I would like to use the POFCON register thresholds to create a crude battery level indicator. I noticed that the POFCON register definition in the nRF52832 Product Spec has...
Hello everyone,
I'm currently migrating from a functional code IAR to Eclipse GCC.
It compiles fine and I got the hex files.
However I have some troube to flash the...
I am working on an application where the nRF52832 is being used to control external hardware that requires fairly precise timing. Specifically, I use sd_radio_request to allocate...
Hello.
I want to develop a custom bootloader with the same purpose as described in Very simple SPI bootloader
I'm using a 52832 with Eclipse/GCC and nRF SDK V13.0
...
Hi there,
I've tried using PCA10040 with NRF Connect to do Secure DFU but no luck. Any idea on how to get it recognized, please?
I'm following this:
infocenter.nordicsemi...
