I have a PCA10059 dongle. I have inadvertently configured pin P0.25 as the sleep debug pin and I use active state 0 as I am using off board LEDs with reverse logic. This means...
If you're working on a product that requires you to show and translate GATT Attribute (Service, Characteristic and/or Descriptor) UUIDs to Strings to the user, it's likely...
Hello,
We have been trying the sendNotification call and after getting a success log we are not able to send a second notification. I'll copy the snippet of code that we...
I have a firmware developed on the nrf52840 development board. When porting it to nrf9160, a lot of errors were reported. How can I use the LOG output function on nrf9160...
Hi I would like to ask you for advice on how to solve my problem with Ble and the timer I am trying to add a timer to examples\ble_peripheral\ble_app_uart the timer works...
Sir,
We finally added WIFI to NINA B302, using a NINA W102 coprocessor!
https://github.com/khoih-prog/WiFiNINA_Generic
Please, enjoy!!!
Here a portuguese BLOG...
Hi,
On nRF5340 development board I followed the instructions in this link and ran the blinky example successfully: Getting Started Guide — Zephyr Project Documentation...
I got an error here err_code = pm_init(); APP_ERROR_CHECK(err_code);
<error> nrf_ble_lesc: nrf_crypto_ecc_key_pair_generate() returned error 0x8502.
<error> peer_manager...
I am using the BLE sniffer in Wireshark (nrf 52840 dev kit board) to attempt to capture packets between a BLE device and android phone. I am able to sniff advertising packets...
Hi,
I have faced an issue with cmsis_v1 thread creation/removal with the SDK connect.
I have created the following ticket on zephyr's side and attached the patch I'm...
Hello,
How to find NRF connect mobile app server's address in the app to be used for connecting to peer devices ? Is there any way that the device address does not change...
Hi,
We are currently implementing the nRF52840 in an upcoming product and we have a question regarding component selection for our configuration.
I've looked through...
Hello
I really need your help !
I am using SEGGER Embedded studio with two EV boards: nRF9160 and NRF52 DK
First I started with NRF9160 with clean installation of the...
Hi
H have developed a program for nRF51822 using "Arduino IED" and "BLEPeripheral" library, that performs an operation.
The operation is a button press and on each press...
Hello,
My board reads data from acceleration sensor and sends it to ESB message.
When acceleration is under threshold, nRF52832 went sleep mode.
Before entering sleep...
Hi...
I am using Nordic SDK V17.0.2 with a SoftDevice S112 and developing a project uses freeRTOS that came with this SDK
From reading the documentation about the...
my project ,sample data every 4ms comes in a GPIOE interrupt ,and in interrupt give a data come semophere , but in thread take this data come semophere and read data can not...
Hello,
I am using NCS v1.6.0 with the nRF52833 DK and would like to modify the TX power (e.g. from 0 to +4 dBm) and PHY (e.g. from 1Mbps to Coded PHY) in the peripheral_uart...
