Hi to all Nordic product lovers,
This is not a question but rather an announcement of a new nRF52840 based finger tip size module 14 x 9 x 1.6mm launched at CrowdSupply...
Hi,
I have a SPI slave device which outputs 8-bit registers that I have to assemble. For example, I receive two 8-bit registers, a high and a low register, which I have...
I have a PCA10059 dongle. I have inadvertently configured pin P0.25 as the sleep debug pin and I use active state 0 as I am using off board LEDs with reverse logic. This means...
If you're working on a product that requires you to show and translate GATT Attribute (Service, Characteristic and/or Descriptor) UUIDs to Strings to the user, it's likely...
Hello,
We have been trying the sendNotification call and after getting a success log we are not able to send a second notification. I'll copy the snippet of code that we...
I have a firmware developed on the nrf52840 development board. When porting it to nrf9160, a lot of errors were reported. How can I use the LOG output function on nrf9160...
Hello everybody, I have an issue related to a peripheral which only lets a connection to be established using the proprietary (brand) mobile application. I try connecting...
Yesterday I want to demonstrate the installed toolchain using the nRF Connect for Desktop.
I got errors and it seems to be required to have internet connection.
Is that...
I try to run https://github.com/NordicSemiconductor/pc-ble-driver/tree/master/examples/nordic_uart_client But the following error occurred.
D:\pc-ble-driver\build\examples...
We do have an eeprom accessed over the SPI, and works well.
Need to add an option to access also the I2C eeprom.
Adding to the project nrf_drv_twi,c, nrfx_twi.c, nrfx_twim...
Hello every one
Pin numbers on DK boards are printed as P0.08 or P1.20 etc. but in nrf_config.h files Nordic assigns numbers to the pins. There are pin numbers from 0 to...
We are developing an application based in nRF5340 using nRF Connect SDK v1.7.0
In this application we have a bootloader for both app and net cores.
Bluetooth is set to...
I am testing UART between PCA10040(nrf52832) and Raspberry Pi 4. I connect TX/RX/GND 3 lines between RPI4 and PCA10040.
On host RPI4 side, my test app send 1 byte to 32...
Hi All,
I just had a quick question about the SDK as it pertains to assigned services. Is the BLE Base UUID defined anywher ein the SDK files? i have looked all over; ble_types...
Segger Studio is capable of reporting Flash usage and Ram usage (heap & stack).
Is there a way to do that without Segger Studio? I'm using gcc, JLink command line tools...
Hello,
I am working on nrf52832 I have set up the SES IDE v 5.5 environment with SDK 17.0.2.
I am getting compilation error "unknown type name 'uint32_t' "
The...
I have a custom model and I successfully configured its publication parameters with bt_mesh_cfg_mod_pub_set_vnd
The model publishes at specified intervals as expected
...
Hi,
I followed this guide to use puncover but failed:
https://developer.nordicsemi.com/nRF_Connect_SDK/doc/latest/zephyr/develop/optimizations/tools.html
I am using...
The Nordic Thingy:91 comes with Bluetooth, and for now most of my deployment will be in areas where I'll be able to connect to it via BLE. I can receive data from my Nordic...
