Hi,
I have a SPI slave device which outputs 8-bit registers that I have to assemble. For example, I receive two 8-bit registers, a high and a low register, which I have...
I have a PCA10059 dongle. I have inadvertently configured pin P0.25 as the sleep debug pin and I use active state 0 as I am using off board LEDs with reverse logic. This means...
If you're working on a product that requires you to show and translate GATT Attribute (Service, Characteristic and/or Descriptor) UUIDs to Strings to the user, it's likely...
Hello,
We have been trying the sendNotification call and after getting a success log we are not able to send a second notification. I'll copy the snippet of code that we...
I have a firmware developed on the nrf52840 development board. When porting it to nrf9160, a lot of errors were reported. How can I use the LOG output function on nrf9160...
Hi I would like to ask you for advice on how to solve my problem with Ble and the timer I am trying to add a timer to examples\ble_peripheral\ble_app_uart the timer works...
Hi,
I'm building an application for the nrf5340 in rust and I want to be able to use the bluetooth LE audio functionality. For this I have two questions:
How can I build...
Hey,
I get the following errors when running my application and I am not sure how to debug this (The nrf thread viewer is empty when I start a debug session of my application...
I try to use one 5340 board as cis client to connect with Galaxy Buds2 Pro and can get the audio in headset.
But the connection is randomly disconnected, the log i get is...
"When I run the CDC ACM example to enable UART, it works fine. However, when I switch to another example that also uses the same USB configuration, the USB port is not visible...
Hello all. I have somewhat of a basic question to ask. I am looking for a USB dongle that can transmit data. runs off of the 5v in the usb and can connect to Win11 by hopefully...
Hi , We are developing a product with NRF5340-CLAA-R WLCSP package IC. While entering the PCB design stage we encountered an Issue with its footprint. First we imported Footprint...
Hello, I am utilizing a Laird (now ezurio) bl5340 module on my custom board which requires the internal 13.5pF caps to be set for the high frequency 32Mhz clock source as...
We managed to get the nrf5430 Audio DK broadcast source application running with two subgroups each containing at least one mono stream and custom metadata about the streams...
Hello,
I am trying to configure an ultrasonic distance sensor with my Nordic Thingy 91. The response from the sensor would be a pulse which will remain high for some milliseconds...
hi
i am working with custom board nrf52833 every thing is working good until i introduced bonding in my code.
i am using sdk 1.9.1 form my development
i released 1.01...
When I was developing a keyboard using the nRF52840 with the NCS SDK, I found that the keyboard couldn't type on macOS when connected via USB or BLE. However, it worked perfectly...
NCS 2.7.0, NRF52840, SYSBUILD with MCUBOOT
We have 1 specific board which is failing with a hardfault and assert MPSL ASSERT: 112, 1617 it occurs whenever we activate...
Hello, we've a nRF9161 DK board a we saw on the back side a footprint for mounting an SD card holder and we found the SD card holder component in the BOM.
Unfortunately...
