I have installed nrf-command-line-tools_10.24.2_amd64 and jLink_Linux_V794e_x86_64 on Ubuntu 22.04. I have also installed nrfconnect-5.0.2-x86_64 for desktop and the Toolchain...
Hello,
We have an NCS v2.2.0 nRF5340 application with MCUboot that requires GPIO control of a few pins extremely early in the startup process. We have a signal "A" pulled...
We are looking for an experienced software developer, for existing board with using nRF Connect SDK. We are using nRF52840-dk.
Please, contact me if you are interested.
Hi Nordic Team, I would like to place mcuboot_secondary in winbond W25Q64JV extenal flash memory for FOTA. I would like perform HTTP application and full modem fota. As my...
Hello,
I would like to use the Asset Tracker V2 application with a custom endpoint that is not nRF Cloud, AWS or Azure. Location services, FOTA would go through nRF Cloud...
Hi,
I installed nRF Connect SDK manually by following the instruction in this page . I had 2 problems but I did a trick and it seems it solved for now. However I need to...
Hi there,
I'm working on nrf52840 & SDK: NCS 2.3.0
I had noticed the MPSL for multi-protocol for BLE & Thread document,but still not found an example in SDK.
Which example...
Hello everyone,
I wanted to use the Central Uart sample application as a starting point for the project on which I am working, but on the documentation
I noticed that...
I have made a custom board with a nrf9160 and am trying to program it via the nrf9160DK. In my testing I was unable to get it to show up or program, although the programmer...
Hello !
I have included to my net core radio driver header
#include <hal/nrf_radio.h>
and expect to use all positive and negative TX power enumerations from nrf_radio_txpower_t...
Hi,
Brand new beginner to nrf and Nordic hardware, I'm trying to build a simple bluetooth application for a BL651 module (nrf52810 chip), and I'm not really sure on how...
Hi ,
It is currently confirmed that the new version of nRF9160-DK (V1.1.0) circuit design integrates GPS_ EN control is connected to the GPIO pin of COEXO. However, the...
Dear Nordic Team,
I want to use the High voltage mode wih all DCD Regulators enabled. On VDD I have connected a Serial Flash with a max current consumption of 20mA. In...
Hi, ppk2 is not identified by the power profiler tool. As a side note, Jlink is identified and works ok.
Tried reset, uninstalling and reinstalling power profiler, and uninstalling...
Hi,
We're using nRF Connect SDK V1.9.1 & nRF Mesh app
During provisioning when we provide Unicast address up 0x0FFF while provisioning it accepts upto 0x0FFF, but when...
Hello,
I am currently working on bluetooth direction finding using AoA. I have a doubt regarding the math involved in the calculation of AoA. It's pretty clear that we need...