Hi,
We are using the nrfconnect for thread and zigbee 3.2.
We have modelled our Bluetooth peripheral, running on the nrf52840, on the BLE UART example. It connects fine...
I have installed nrf-command-line-tools_10.24.2_amd64 and jLink_Linux_V794e_x86_64 on Ubuntu 22.04. I have also installed nrfconnect-5.0.2-x86_64 for desktop and the Toolchain...
Hello,
We have an NCS v2.2.0 nRF5340 application with MCUboot that requires GPIO control of a few pins extremely early in the startup process. We have a signal "A" pulled...
We are looking for an experienced software developer, for existing board with using nRF Connect SDK. We are using nRF52840-dk.
Please, contact me if you are interested.
Hello to all
I am yet to find a way to turn off DTLS when using the lwm2m client sample. When 'CONFIG_LWM2M_DTLS_SUPPORT=n' is set, the lwm2m engine is unable to run....
Good day
I have used the previous versions of thngy91 built in sensor(BME680) successfully . However, I have found that the latest version of the sample doesn't use the...
Hi, my today's task is to replace a Pheriperal device in a customer BLE system (Target: nRF52820). Finally I've managed to setup ADV_IND and SCAN_RSP data packets the same...
I'm getting the following error at compile time:
In my main, I'm using the following code (reduced to the relevant part):
I'm also using the bas_client...
Hi there,
We have integrated the nRF52840 into our PCB. Currently we're building our firmware with '-b nrf52840dk_nrf52840', but we were wondering if it's possible to build...
Whilst using connect SDK , to allow us support of BT etc, we need to access low level IO directly ideally without going through your OS type interface.
Simply put we need...
I followed all the steps from the website: https://developer.nordicsemi.com/nRF_Connect_SDK/doc/latest/zephyr/develop/getting_started/index.html
But I get the following...
I'm using very faithfully (since some year) module MC01DP5 based on nRF24L01+, produced by EBYTE.
A lot of boards equipped with this module are around the world.
Lately...
Hi,
When I try to open any application/tool in nRF Connect 3.12, it does stuck in loading screen. I tried reinstalling everything, but it didnt work. I have downgraded the...
I am interfacing nRF to a GPRS modem. In order to ensure the modem is in a known state I do a power cycle of the modem and I determine completion by monitoring the TX line...
Hello,
I observed a strange behaviour which I would rate as a Compiler bug but it could be also a language feature which I didn't know until now.
I have the following...
Hello Nordic,
Please don't change the format of nRF Connect SDK version number from v2.2.0 to v2.2.99-dev3. v2.2.99 is fine but no v2.2.99-dev3. The dev2, dev3, dev 4...
Hello,
I am using nRF5 SDK v17.0.2 as my development environment for this project. My goal is to retransmit the same command as quickly (and as many times) as possible in...
Hi,
1. In what range of rsrq, nRF9160 can be stably connected to the network?
2. In what range of rsrp can nRF9160 be stably connected to the network?
3. Which parameter...
