Hi,
We are using the nrfconnect for thread and zigbee 3.2.
We have modelled our Bluetooth peripheral, running on the nrf52840, on the BLE UART example. It connects fine...
I have installed nrf-command-line-tools_10.24.2_amd64 and jLink_Linux_V794e_x86_64 on Ubuntu 22.04. I have also installed nrfconnect-5.0.2-x86_64 for desktop and the Toolchain...
Hello,
We have an NCS v2.2.0 nRF5340 application with MCUboot that requires GPIO control of a few pins extremely early in the startup process. We have a signal "A" pulled...
We encountered two bugs in our own firmware that put the device into a really bad state and so I wanted to ask what the practices are to avoid this.
One bug we got stuck...
Hello,
during advertising, the measurements done with PPK2 show unexpected peaks.
Advertising parameters:
- interval: 1,8 sec
- TX power: -12 dBm
This is the...
Hello,
I am working on a thread based project for a class and I was wondering if it was possible to receive an MQTT packet directly from AWS through the border router...
Hello to all
I am yet to find a way to turn off DTLS when using the lwm2m client sample. When 'CONFIG_LWM2M_DTLS_SUPPORT=n' is set, the lwm2m engine is unable to run....
Good day
I have used the previous versions of thngy91 built in sensor(BME680) successfully . However, I have found that the latest version of the sample doesn't use the...
Hi, my today's task is to replace a Pheriperal device in a customer BLE system (Target: nRF52820). Finally I've managed to setup ADV_IND and SCAN_RSP data packets the same...
I'm getting the following error at compile time:
In my main, I'm using the following code (reduced to the relevant part):
I'm also using the bas_client...
Hi there,
We have integrated the nRF52840 into our PCB. Currently we're building our firmware with '-b nrf52840dk_nrf52840', but we were wondering if it's possible to build...
Whilst using connect SDK , to allow us support of BT etc, we need to access low level IO directly ideally without going through your OS type interface.
Simply put we need...
I followed all the steps from the website: https://developer.nordicsemi.com/nRF_Connect_SDK/doc/latest/zephyr/develop/getting_started/index.html
But I get the following...
I'm using very faithfully (since some year) module MC01DP5 based on nRF24L01+, produced by EBYTE.
A lot of boards equipped with this module are around the world.
Lately...
Hi,
When I try to open any application/tool in nRF Connect 3.12, it does stuck in loading screen. I tried reinstalling everything, but it didnt work. I have downgraded the...
I am interfacing nRF to a GPRS modem. In order to ensure the modem is in a known state I do a power cycle of the modem and I determine completion by monitoring the TX line...
Hello,
I observed a strange behaviour which I would rate as a Compiler bug but it could be also a language feature which I didn't know until now.
I have the following...