Hi everyone,
I'm working on a project using the Nordic nRF5340 microcontroller and I need to count both rising and falling edges of a square wave signal on pin P0. 14, coming...
Hello, I’m working with a combination of nRF5340 + nRF7002 + NPM1300 , and I’ve only changed the I2C pins connected to the NPM1300 to sda pgio1.4 and scl gpio1.6 .
SDK...
I am running into a secure fault when I set the NVS_SECTOR_COUNT to >= 7, not sure how to proceed.
it fails at nvs_mount(&fs)
I have added a nvs_storage partitation...
I've seen other threads about the issue:
- https://devzone.nordicsemi.com/f/nordic-q-a/117267/light-bulb-sample-works-on-nrf52840dk-and-doesn-t-on-nrf52840-dongle
- https...
Here is my script for programming. Does the sequence is OK? or any advice to improve?
nrfjprog --eraseall
nrfjprog --recover --family NRF53 --coprocessor CP_APPLICATION...
Using the peripheral_uart example routine from the NCSv3.0 library with the 54l15 chip.
1. compilation command： west build --build-dir build . --pristine --board nrf54l15dk...
I'm looking into a rare issue on the BBC micro:bit V2 which uses the nRF52833 as its (application) microcontroller. I used to be familiar with some CPUs from the 80s but my...
Hi,, I'm trying to set a recv timeout on a UDP socket (coap) using setsockopt() and getting an EPERM error. I've tried the setsockopt() call both before and after the (successful...
I'm attempting to use AWS IoT Just In TIme Provisioning(JITP), but no luck. Any help.
I tested JITP on my account, not Nordic one, with local mosuqitto client on Mac and...
I'm trying to use aws_fota, but it doesn't work. Any help?
I was able to set a job on AWS IoT, but the download job doesn't start. The job status is always "in progress...
Hello
I am writing a peripheral emulator application on android. My peripherals include 2 services and 4 characteristics. I tested my application with nRF Connect on the...
Hello All,
I am working on nrf52810 board
Using sdk 14.2
I am trying to modify some bytes of advertising packet .
I am referring the previous post as link given...
I'm getting ERROR 12 upon calling ble_advertising_init. I understand that this is caused by exceeding the advertising packet max payload of 31 bytes. What options do I have...
Hi All,
I am testing the performance of a Relay Node in a mesh network.However it seems don't work.
I would like to show that the Relay node operation such as Rx and Re...
I am working on nRF52832 platform and my version of softDrive is (nRF5_SDK_15.3.0_59ac345), I am wondering in my application what is the data packet length and can Increase...
I have flashed my Thingy:91 via the nRF9160 DK using the Programmer with the pre-built at_client software, but I am unable to get any AT response when I connect using the...
Hi,
I'm using SDK v15.3.0 which has s132 6.1.1 to program an nRF521832. I had a single custom service on my stack and that was working well. I added a second service and...
I'm Currently working on nRF52840. I am trying to change Name for Beacon received from one of the Beacon's Characteristic and storing it in Flash. Now for name I am changing...
Good afternoon,
I'm connecting my nrf52840 device to my laptop, and it only shows up when being put in bootloader mode. Is there any way to fix this? Thanks in advance.
