Hi,
I recently found out about the Periodic interval feature on GRTC CC[0] and it seems like it would be quite useful for my application. Most of my code so far uses the...
Hi,
I have integrated Neuton’s “Transport Type Detection” pre-trained model into my firmware, running on a nRF52840dk. For collecting 9-axis IMU data, I’m using the ST X...
I'm trying to implement a fall detection feature on the headset side using the LSM6DSOX IMU sensor. The IMU is configured successfully, but the board halts after the INT1...
I have a ready hogp struct and I'm trying to subscribe to an input notification (I'm connecting to a bluetooth keyboard) and I'm getting error -22. Here's the callback in...
Hello,
I am trying to count pulses on nRF52840 DK's pin for measuring water flow with hall effect sensor. I tried to implement PPI + GPIOTE + TIMER in counter mode, but...
Hi, I am using nrf52840-based custom hardware and have an external flash connected on SPIM3. Till now I was working with my other peripheral connected on different buses and...
Hello Nordic Team
I am using SDK 3.0.1 with a nRF52DK to develop a firmware that can be switched from BLE mode to GAZELL mode and vice versa over a command sent via UART...
from this post link text i have again doubt
i define #define APP_ADV_TIMEOUT_IN_SECONDS 10. now my advertising stops after 10 sec.but i want to restart it again then??
I am trying to understand the difference between the timer driver and the app_timer library.
First of all: It seems like timer and app_timer are two entirely different things...
Hello,
I have a nRF51 DK (PCA10028) and I managed to programm an onboard nRF51422 SoC. Now, I'm trying to programm a nRF51822 on a costum board (WT51822-S2). I wanna try...
nrf51822 SDK 9.0
iphone 6plus System version IOS9.2
When the phone receives the QQ message "static void notif_print(ble_ancs_c_evt_notif_t * p_notif);" can execute.
but...
I am programming with mbed, and i am trying to start the adc-task via ppi and timer cc events.
another ppi channel is used to toogle the LED.
I am using the nRF51822 on...
Hello There,
I am looking to use many of the features found in the SDK Common Library such as the application timer. I am looking at the documentation and I am unsure how...
According to the S132 v2.0.0 release notes it states:
"minimum required memory - actual requirements are dependent upon the configuration
chosen at sd_ble_enable() time...
I need to implement the micros() function of arduino on nrf51822. Can someone guide me on how it can be done?
This the function for Arduino:
unsigned long micros() ...
We have two developers running the same version of IAR and the SDK and one of them has different device options under the project options. My IAR project works with NordicSemi...
Am using SDK 8, Single or dual bank serial bootloader brick during SoftDevice upate. Brick happens only if softdevice CRC validate fails(Stop Cmd). During CRC validate pass...
I'm connecting to the same microcontroller with nRF Master control using the same firmware, but I noticed that the connectivity time is not similar with every connection....
Hi guys,
I have a question when design the pcb layout stack with nRF52832, CSP package (CHAA). As recommendation from Nordic, using 4 layers will give best performance...
I noticed that Digi-Key had a new part number for the nRF52 DK that wasn't designated "Preview", so I assumed it might be the final silicon. However, nRFgo Studio identifies...
Now I work on designing a product, which is implemented by sending LMP commands to a bluetooth device with nrf51822. Unfortunately, nrf51822 liberary could not provide the...
