I am trying to get a good handle on the difference in average power consumption between BLE point to point and Zigbee on an nRF52840. We have battery powered products and...
Hi, For my project, I need to design a BLE packet sniffer which scanning the 40 channels. Therefore, I need 40 dongles are connected to a computer that can read and transfer...
I am writing code to get a nrf52840 DK to associate with an existing 802.15.4 coordinator using the 802.15.4 API module within SDK 15.2.
I've called "mlme_scan_req" and...
Currently, I am able to use Mqtt Publisher or Subscriber with only one Nrf52 device. I can ping to the device with link-local address.
I am using Nrf52832 with SoftDevice...
Hi everyone,
After days of figuring out how CMake works, I try to write a CMakeList.txt myself, and decide to put my progress on this community. Right now, using CLion with...
i am using nrf 52832, i got SAADC example code from sdk. that code done by using timer. i could not understand timer section. Is available SAADC simple example code without...
Hello everyone,
as indicated by this question https://devzone.nordicsemi.com/f/nordic-q-a/35692/adding-nrf52-dk-to-github-mesh-demo-for-thingys/138327#138327 I am trying...
Hello,
I have a question regarding the nRF5340 microcontroller or similar. Usually, when programming UART, I2C or SPI bare metal, one is using interrupts, register and buffers...
Hi Team,
We are working on project where we are trying to encrypt the advertisement data (non-connectable) using our own defined keys.
currently I have been through the...
Using Segger with PCA10056 as a debugger connected to a pcb with a NRF52840 on it. Been working fine and I tried building open bootloader and programmed it. I see the device...
Hello,
I am a newby to the nRF5340 and Zephyr and I am stuck. I would like to know how to map physical pins to a particular UARTE.
I have read in the user manual OPS_v0...
Hello,
Currently developing a system based around the NRF9160 running Zephyr. My application is threaded and i would like to run the thread_analyzer. I got this working...
Hello,
I want to hide the BLE(RF signals) completely soon after updating the configuration in my application and whenever I need to update the config I should be able to...
Hi, I'm reading an ADC channel connected to large capacitors. I do the read when charging is off so no ripple. The caps are large (super-caps) so hold well enough to show...
Hey. If the device is repeatedly flashed without turning off its power (it does not matter if I program it through SES or nRFgo), it may start to malfunction or slow down...
Hello
I would like to use three PWM to output multiple sounds with one buzzer.
First of all, I am testing using two PWM. There is no problem using only one PWM, but there...
Hi, I'm currently using TAIYO YUDEN's EYSLCNZWW (nRF52810) and We are developing a device like a pulse oximeter.
I would like to change SAADC_SAMPLE_RATE from 400ms to 100ms...
Hi, after using the nRF SDK examples with SES for some time now, I decided to go with a project from scratch but for some strange reason the directory where I keep the nRF...
Hi everyone,
I am using the custom nRF52840 module provided by Raytac. I integrated into my evaluation board and I flash it using SWD and JLink debugger. My problem is that...
I have DFU code base working. It consists of a thin layer of our code, and majority is from Bootloader component from SDK v17.
I started with DFU OTA, and then incorporated...
