Hi,
I am a bit confused about power consumption when using app_uart_fifo. To save power I put MCU to sleep in between each sent and received byte by using __WFE and __SEV...
Hi! I am building an android app for my project. I am using Proximity , UART and DFU from nrfToolbox app. I have 3 buttons on my home screen dedicated for each of them. I...
Dear Nordic employee:
1、 what do I have?
I have a thingy52 develop kit（nrf52832）
2、what is my purpose?
the quality of thingy52 audio demo is not good（iphone7）...
Hello Nordic,
My development environment:
SDK>> NRF51822_SDK10, SoftDevice>> S130
Example>> ble_app_uart
I am looking forward to your reply!
Thanks.
Best Regards...
Dear friends,
according to "nRFConnect_BLE_User_Guide_v2.0", to set up a local device,i should complete the following steps:
Connect a development kit or dongle to...
Hi
I have add some function call like sd_ble_enable in mesh example, I test to get
then I set the address and all sd_ble_cfg_set is ok
but when I call "sd_ble_enable...
Nordic \ nRF5_SDK_12 nrf52832 using 2.0 _f012efa \ examples \ peripheral \ pwm_driver, pwm_driver example
Want to set up two road PWM phase is different, for example, the...
Hi, I am using the UART over BLE example + a timer interrupt + a pwm signal. And I am facing the following problem (error launched by my phone app: ) This happens sometimes...
Hi ,
In order to capture and get the data from the external BLE beacons,
I am trying to simulate this using nrf connect Advertiser option instead of using Beacons...
Hello, i have been unable to read data from my sensor.
uint8_t SPI_ReadByte(uint8_t RegAddress) { ret_code_t retCode = NRF_SUCCESS; //start reading sequence m_tx_buf[0...
The modem reports that it supports states 0, 1, 4, 20, 21, 30, 31, 44 when I give the "AT+CFUN=?" command.
Using the at_client sample, or other software like asset_tracker...
Hi, I am using nRF52 DK with s112 and SDK V15.2.0. I have written an application based off of the uart example, and expanded it rather substantially to use the SAADC and read...
Hi,
I'm trying to create my switch_event by using Event Manager.
And I got this issue: "undefined reference to `__event_type_switch_event' " when submitting my event:...
Windows 10, Segger V4.52c, S132, SDK 15.2.0, nRF52832
I've been through a few posts talking about needing more RAM allocated to the SoftDevice when other services are added...
Is it possible to generate a DFU package for both bootloader-only and fully-programmed (bootloader, softdevice, and app) chips? I'm unable to do so for an nrf52833 using nrfutil...
Converting old code for a nRF51822 to the new SDK(15.3.0) for an nRF52832, this error happens:
#error "Compiler generates FPU instructions for a device without an FPU (check...
Hi all,
After wasting so much time trying to set up simple peripheral device whitelisting single central device, I realised that API has been updated and those old examples...
Hi all,
Can I read the chip ID of NRF24LE1 in code? how can I get the ID?
Or is there any readable identifier that make each chip "unique" from each other? Because the...
