Hello,
We have an NCS v2.2.0 nRF5340 application with MCUboot that requires GPIO control of a few pins extremely early in the startup process. We have a signal "A" pulled...
We are looking for an experienced software developer, for existing board with using nRF Connect SDK. We are using nRF52840-dk.
Please, contact me if you are interested.
i burnt the fb63 and now NRF52840 is not able to power up. even desoldered the FB63 and put a short on the particular pads. THe eval board is still not able t power up. Is...
hello Nordic
i want to use nrf21540 dk to run a simple Bluetooth / beacon example with the ncs (v 1.9.2) i do not see some rise in dbm power with the nrf connect android...
Hi.
In my current project with nRF52832, I have used the following port pins to connect it to an accelerometer and a SPI flash memory:
I would like to ask, get opinions...
I want to setup pairs of nRF51-dongle and nRF51-beacon where dongle-1 will always bond with beacon-1, dongle-2 with beacon-2, etc. If dongle-1 and beacon-2 are switched on...
Hello,
I am using the ADC input on the nRF52 DK and its working correctly. Its setup right now to use its Internal Voltage as Reference. I wanted to know if there is anyway...
in nrf52832 ，We know that there is a process of RF signal ramp up between tx en and tx ready signals. Will RF signals be transmitted during tx ramp up preparation time? If...
Hello there,
I tried combining the GNSS simple sample code to my edited version of the MQTT simple sample code and I am unable to build anything. I am getting this error...
Hi
I am currently trying to create ADC and BLE Services using nrf5340 DK for evaluation before jump to custom board. So based on several threads in this forum, I found this...
Hi,
I am developing my application on top of low power node example available nrf sdk for mesh v5.0.0. The idea behind the application is that after the node is provisioned...
Hello there!
The nrf52832 qfaa reference circuit uses a coplanar waveguide for the antenna section, leaving a keep out area on the inner layers beneath the matching network...
Hi,
I wont to disable serial to lower the power consumption on my Icarus board. I am using the AWS IoT example which uses the AT HOST Lib. If I try to disable serial using...
Hi there,
I was using a PCA10040 DK (V0.9.0, 2015.49) to try out nRF Connect SDK samples (peripheral_lbs) and suddenly found I couldn't program, erase or recover the device...
