Hello Nordic,
My development environment:
SDK>> NRF51822_SDK10, SoftDevice>> S130
Example>> ble_app_uart
I am looking forward to your reply!
Thanks.
Best Regards...
Dear friends,
according to "nRFConnect_BLE_User_Guide_v2.0", to set up a local device,i should complete the following steps:
Connect a development kit or dongle to...
Hi
I have add some function call like sd_ble_enable in mesh example, I test to get
then I set the address and all sd_ble_cfg_set is ok
but when I call "sd_ble_enable...
Nordic \ nRF5_SDK_12 nrf52832 using 2.0 _f012efa \ examples \ peripheral \ pwm_driver, pwm_driver example
Want to set up two road PWM phase is different, for example, the...
I'm using nRF52832 and S132 based on nRF5 SDK v14. I get a error code 4 when I add DFU service refer to the experimental_ble_app_buttonless_dfu . The SDK has changed so much...
Hi,
I'm wondering if I can get current transmitting channel during a connection. So
Is there a way I can directly read current transmitting channel?
If not, is...
This question has to do with the observed "recursivity" of the calls to "app_sched_execute" in SDK13 as described in the previously asked question below:
devzone.nordicsemi...
Hi!
SDK15, s132, SD6.0.0, nRF52832
I have nRF52832 in central mode and some bonded HID devices and another nRF52832 peripherial devices.
Now in the my central nRF52832...
I simulated the balun of nrf51822 accroding to the referenced design of nrf51822 on the official website. However,it showed the differential phase of the balun was not 180...
Hello team,
We are using CPU NRF52832/810. We have followed the THINGY hardware for BLE Antenna with Ceramic Chip. Due to our range requirement more than 100 meter, we wanted...
DK : nRF52840
SDK :15.3.0
example code : nRF5_SDK_15.3.0\examples\peripheral\flash_fstorage
I watched that using nRF52840 DK is best way for develop nRF52811. So I...
Hi,
We have a product that uses nRF52832, we are trying to get the FCC Certification. We are using the RF test example to setup the DUT.
We are able to get the signals...
Hi,
I wanted to use Nordi UART service, the problem is that if I have no contraction with the device, it would not advertise after a definite time, say 180 Seconds, my devices...
I'm trying to connect nRF916 FP1 Preview DK to LTE-M network using LTE Link Monitor but it fails. Below is details about my firmware/software:
Zephyr OS v1.13.99-ncs2
...
Hello,
I am currently working on nRF52840 DK while waiting for my custom board using this chip.
This custom board will include Toshiba external flash of family TC58CYG2S0HxAIx...
Please understand that it is English using a machine.
Hello. I try to create a module using nrf52810 and nrf52840. We are testing "secure_uart_pca10040_s112...
Hi,
the bootloader addr is start form 0x28000, and I checked my application code, it only reached 0x25B00.
I called the fstroge to erased a page Flash start from 0x27000...
We going to test the link range of mesh networks (BLE mesh the first and Thread later) inside the building - between the floors.
It's possible the hop between the floor...
