Hello Nordic,
My development environment:
SDK>> NRF51822_SDK10, SoftDevice>> S130
Example>> ble_app_uart
I am looking forward to your reply!
Thanks.
Best Regards...
Dear friends,
according to "nRFConnect_BLE_User_Guide_v2.0", to set up a local device,i should complete the following steps:
Connect a development kit or dongle to...
Hi
I have add some function call like sd_ble_enable in mesh example, I test to get
then I set the address and all sd_ble_cfg_set is ok
but when I call "sd_ble_enable...
Nordic \ nRF5_SDK_12 nrf52832 using 2.0 _f012efa \ examples \ peripheral \ pwm_driver, pwm_driver example
Want to set up two road PWM phase is different, for example, the...
I'm using nRF52832 and S132 based on nRF5 SDK v14. I get a error code 4 when I add DFU service refer to the experimental_ble_app_buttonless_dfu . The SDK has changed so much...
Hi,
I'm wondering if I can get current transmitting channel during a connection. So
Is there a way I can directly read current transmitting channel?
If not, is...
This question has to do with the observed "recursivity" of the calls to "app_sched_execute" in SDK13 as described in the previously asked question below:
devzone.nordicsemi...
I don't fully understand datasheet for LFXO.
17.4.3
CL_LFXO Load Capacitance = 12.5pF. Is this the recommended CL for external crystal?
RS_LXFO ESR = 100k. Is this the...
Hello everybody,
I'm developing a webapp that need to communicate with my BLE device, an nRF52 DK Board.
The firmware has some open and some encrypted characteristics...
Hello!
I am new to the Nordic chips and for my project .My question is when i use the timer example (nRF5SDK1702d674dde\nRF5_SDK_17.0.2_d674dde\examples\peripheral\timer...
This is really a shot in the dark. I'm working on a BLE application using an nRF52840 that communicates via an Aruba Networks wireless network. Specifically I'm using an Aruba...
We are currently working on a project where we use a NRF52832 in a beacon to act as a keyfob for another device. We are concerned that if we lose the key we cannot use the...
Hi, I trying to integrate a thread inside a function to run in parallel with the main program.
I have tried the THEAD_DEFINE function and it works but it is static and has...
Hi,
Just today my J-link EDU mini - NRF52 donlge combo stopped working. I do the following:
1. nrfjprog.exe --recover
2. nrfjprog.exe --eraseall
3. I use J-Flash lite...
I have procured nRF52840 Dongle and i followed the instructions as mentioned in the link https://infocenter.nordicsemi.com/pdf/nRF52840_Dongle_User_Guide_v1.1.pdf and i am...
Hi,
I'm use the Anritsu 8852B that be production flow.
My hardware setup is OK that be verifyied by DTM tool.
" Bluetooth low energy Measurement Software " always show...
Hello,
I am using nRF52840 with our custom board. In that, I am implementing the DTM firmware for test radio.
I was able to receive packets but when I try to read the...
Hello
I would like to protect some Bluetooth characteristics in order to protect them from eavesdropping.
In fact, here is my problem: I would like to make an application...
