Hi,
I am a bit confused about power consumption when using app_uart_fifo. To save power I put MCU to sleep in between each sent and received byte by using __WFE and __SEV...
Hi! I am building an android app for my project. I am using Proximity , UART and DFU from nrfToolbox app. I have 3 buttons on my home screen dedicated for each of them. I...
Dear Nordic employee:
1、 what do I have?
I have a thingy52 develop kit（nrf52832）
2、what is my purpose?
the quality of thingy52 audio demo is not good（iphone7）...
Hello Nordic,
My development environment:
SDK>> NRF51822_SDK10, SoftDevice>> S130
Example>> ble_app_uart
I am looking forward to your reply!
Thanks.
Best Regards...
Dear friends,
according to "nRFConnect_BLE_User_Guide_v2.0", to set up a local device,i should complete the following steps:
Connect a development kit or dongle to...
Hi
I have add some function call like sd_ble_enable in mesh example, I test to get
then I set the address and all sd_ble_cfg_set is ok
but when I call "sd_ble_enable...
Nordic \ nRF5_SDK_12 nrf52832 using 2.0 _f012efa \ examples \ peripheral \ pwm_driver, pwm_driver example
Want to set up two road PWM phase is different, for example, the...
I'm looking into a project that needs to have BLE to communicate with a user and a mesh network to communicate with multiple data gathering nodes connected by 2.4GHz RF links...
Hi,
I am using nrf52832 for my application. The application share same SPI module for two sensors(with sensors are selected using two chip select pins). Is it possible...
Hello ,
following are my requirements :
to create a secure bootloader which checks app validity at every boot .
the boot loader should also accept UART communication...
I have an Eddystone beacon from minewtech...i've downloaded the nRF connect app onto my android tablet and i can connect to the beacon. the problem is that it's not "taking...
On the nRF51822 Is it possible to check the battery level using the on-board AD, software connected internally, avoiding external resistor divider.
If not what is the best...
Hello,
I've been trying to migrate a project from the nrf51822 that uses s110 7.1.0 softdevice to the nrf52832 s132 1.0.0.3 alpha softdevice. I had to change some given...
How can I found out my NRF51's device Address? (with Softdevice using Random static address?)
Does Softdevice has any API for fetching my device's BLE Address?
As I...
I'm looking at the sequence diagrams for the secure bootloader, and I'm confused about the response procedure opcode for Packet Receipt Notifications (PRN). From the diagram...
Hi
for a new project I need to combine bluetooth with 2G/4G cellular communication, and augmented positioning, meaning we want to use cell tower, GPS and scanning of Wifi...
hai
i want to store a struct contains two elements . can i store it in flash using pstorage....?
if so how can i do that.........?
or
can i store a two dimensional...
I want at s132 use RT-Thread RTOS,but I see arm_startup_nrf52.s file defined Stack_Size and Heap_Size 8K, can define Heap_Size = 0? reduce the Stack_Size (such as 4K)?
so...
Hi,
I want to know that what is the different between RS232 and TTL.
I want to know that can we two RS232 to TTL converters back to back in the wire ??
