I want to communicate Central and peripheral devices with KeyPass. Also I want to generate keypass in Peripheral device. But keypass should to include symbols, low/upper case...
I am using SEGGER Studio on MacOSx.
When use the latest mesh SDK, I can run the light_control example and see the debug log in the Debug Terminal of SEGGER Studio.
However...
Hello,
I'm trying to setup a nRF Cloud Bluetooth gateway using my PC (with openSuse 42.2 64bits and rRF Connect v2.1.0 + nRF Cloud Gateway v0.9.7) and a nRF52 DK and I...
Hello: I am using an NRF51 dongle. Date on the device sticker on the back is 2015.38. Also using nrf51_ble_driver_linux_0.5.0.
I can see/connect to the device I am trying...
Hey,
I just want to know if anybody sucessfully connected HDMI CEC (One-Wire bus) with the nRF52832.
I would be very grateful if anybody could share the library or give...
As the tittle,can anyone tell me how to save data to the flash with nRF51822 ? I use SDK9.0.0 and S110. before I turn off my machine, I want to save several parameters to...
Can I calculated elapsed time from one event using TIMER1?
If yes,how?I can not find none register which one to read for get counter value(how many ticks have passed since...
Hello, I follow
this page to start the rpi2 for 6lowpan.
when I tried to run RADVD Daemon as follow:
Set IPv6 forwarding (must be present).
sudo echo 1 > /proc...
Hello!
I recently purchased a RedBearLab nRF51822 board where I want to use several DS1820 temperature sensors.
For dealing with the OneWire (1-wire) protocol I found...
Hello,
I'm not sure if this was already asked before. I didn’t found a similar question, so here it is: When I have a function that manipulates a data structure to communicate...
In this ADC example from Nordic on GitHub, it does not appear an AIN has been selected (e.g.: no call to nrf_adc_input_select() ). I don't understand. I have been assuming...
Hi,
I am creating a central application on a Nordic nRF51 device. Our project is related to connecting to peripheral of any profile. Using the MCP I connect, bond and enable...
Hello,
For our application I have to set up two simultaneous connections between a S120 master device and two peripherals that use the S110 softdevice.
A very short connect...
Trying to send 3 20-byte packets of data from nRF51822 (peripheral device) to a Samsung Galaxy S5 (central device) and send 1 20-byte packet back, all in less than 10ms. I...
Hello,
I'm looking to bootloader sources and i want to add a timeout if entering with a signal in DFU mode and no DFU detected for one hour.
There is a timers_init function...
I have a project that requires full-duplex voice comms (doesn't need to be high-quality). I'm evaluating the suitability of BTLE for the task. The new nRF52 has a PDM module...
I'm moving to Nordic from "another" BLE s.o.c. where the UUIDs, profiles, services and characteristics were defined in XML. With that product I could modify or examine or...
