I would like to test the newly added v4.2/v5.0 Bluetooth features (e.g. LE Secure Connections, Data Packet Length Extension, 2xSpeed, etc) against non-nordic devices. I have...
I am working on a project using a ble nano (nrf51822) using the Nordic SDK 8.1. In the examples I found a way to control an LED using the methods LEDS_ON and LEDS_OFF. I wanted...
Hello,
I am using ble_app_gls example and I have implemented static passkey in the code. Now I want to see if wireshark shows the passkey when I connect to ble devices. For...
Hi Team,
We are implementing an UART communication between a M4 processor (UART master) and a nRF51 (UART slave) and we want to use the UART in Low Power mode with flow...
Hello everybody,
for my project, i will bond the peripherial with the central.
I test my device with the MCP and can connect without problems. When i press the Bond Button...
Hi all,
I am trying to count the positive edges of a 3.5MHz signal with GPIOTE, PPI and the TIMER1. Unfortunately i can only measure to frequencies up to a little more...
Loaded Softdevice S140, ( Using NRF52840 DK board ) using NRFgo Studio.
App flash base is set to 0x00021000 and app RAM base is set to 0x20003000
Looking at the CPU...
Hi,
I am new to Nordic cellular modems, but plenty experienced with other modems. I would like to evaluate the nRF9160 as a potential candidate for future use in our products...
Hello,
I am having a problem nearly identical to this link Using soft device on custom board with nRF52840 - Nordic Q&A - Nordic DevZone - Nordic DevZone (nordicsemi.com...
Hello,
I am running a single ( main() starts sysworkq thread) thread application in Segger Embedded Studio v5.34a, built for the nRF52833 SoC.
Although I am using a proprietary...
Hi
We are seeing a strange issue when trying to use the Android BLE Library to Android BLE Library to reconnect to two devices. The phone succeeds in connecting to one device...
Hello,
I am going to run DFU over the mesh.
I am using an nrf52840DK and two nrf52840 dongles. I want to send a DFU file through the serial port to the DK and then through...
Hello,
during production test we wrote in the UICR a signature saying that the test has been performed succesfully.
It happens that the signature is not written correclty...
Hi, I'm really pleased with myself as I have set up my VS Code in windows to build and clean blinky and can drag the _build hex file to nRFConnect and flash it to my dongle...
Dear Nordic,
When testing the DFU process, I noticed something unexpected. We are using the secure DFU USB bootloader, with forced dual bank updating. I'll attach both the...
I am using ibeacon format for my device. The specification says to include the RSSI value calibrated at 1 meter in the payload.
Can you please tell me how to find out...
Hi,
We managed to integrate both normal BLE and mesh stack onto our working prototype, powered by nRF52840. So far, it is working well. We are trying to further maximise...
I am using the NRF52840 controller to connect BMD101(ECG sensor) uart based having a baud rate of 57600.
Note: Using UART peripheral example on SDK17
I am trying to parse...
Hi
I've problem on my design when I use voltage translator to communicate with sensors. Can you guys see pictures below:
1.nRF52840 using 3.3v:
1.nRF52840 using...
Hi all.
I want to send my packets in the negotiated time interval.
I sat the NRF_SDH_BLE_GAP_EVENT_LENGTH to 6.
The negotiated TI is 36 ms.
the results are
1- the...
