I'm using an nRF52 (SDK11.0.0, s132) and am able to generate a hex and axf via Keil/uVision. It uploads and works just fine using a Segger J-Link. I want to try some lower...
Hi, I'm a newbie to Nordic and need to use multiple nRF24LE1s to get ADC values and transmit them to a single nRF24L01 connected to an Arduino. I need sample Keil compiler...
HI:
i hava a sender and it send a frame every 15ms ,not use any protocol,and reciver code like as follow:
while (1) {
Rf_StartRx(ReciverSC.RfBufPointer...
Hi to everyone,
i have an mb39c811-evsk-02 and over it there is a tmp102 temperature sensor and an nrf51822.
I want to read the values of the sensor over a beacon app. ...
Hi,I'm glad you can see my post.
Now, I am in a program to read and write FLASH such as the screenshot in the attachment.
Then I update with DFU service for the equipment...
Hi Is it possible to change the MTU size with the Master Control Panel?
I am making a ble device on a nrf52 with the SDK 12 (latest softdevice) which has the ability to...
Is there a function like battery_level_in_percent for AA battery?
I know battery_level_in_percent is only for CR2032.
Even though I compensate it to make it 3V from AA battery...
Hello,
I'm attempting to connect the nRF9160 DK to our AWS IoT account. I've been following the information in this question: https://devzone.nordicsemi.com/f/nordic-q-a...
Hi, looking for some advice regarding hardfault analysis. Using NRF52840 with SDK 15.3 and SD 6.1.0, i am seeing occasional hard fault (after ~30 min to 2 hours), during relatively...
Hi,
I know it is a silly question but I would like to ask does nRF52810 support SPI, TWI, UARTE etc.
Below is block diagram from datasheet of nRF52810 which shows it has...
Hello,
I was able to flash demo .hex to my nRF52840DKs from this ( https://github.com/NordicPlayground/nrf52-ble-multi-link-multi-role ) project, but now I would like to...
I alway used direct UART command with nRF24AP2 and CW test was not a problem.
Now with nRF52xxx and S212 softdevice I try this ... but nothing works .
sd_ant_stack_reset...
I've used Segger Embedded Studio to compile and run a number of example projects -- nicely done!
Now I'm ready to start creating my own projects, with the ultimate goal...
hello,
i'm trying to communicate between a central device and a peripheral.so if multiple peripherals are present and all of their mac id is known.how can i select a particular...
SDK 14.2
i just added peer manager to an existing project, and peer manager seems to be working correctly. pm_peer_data_app_data_store() is successfully called to save addition...
Hi!
I'm currently in the process of evaluating the nRF9160 DK. I'm trying to measure the current of the LTE when the PSM mode it's set. I'm using the at_client application...
Hi team,
My customer found that our SDK15.3 is supporting FreeRTOS version 10, but their original codes are based on FreeRTOS version 9, do we have any guideline which version...
Dear expert
I have created a keil project according to the example of light_switch with Segger_Embedded_Studio IDE in nrf5SDKforMeshv310src, and when I build the main source...
HI All,
I wanted to configure nrf52810 as TWI Slave for one of my application. Am not able to find any example related to TWI Slave configuration
Please let me know if...
