Hi Guys,
I know this is more for software issues. But I was curious as to where I can find trusted case providers/makers for the nrf51822 Beacon. Can anyone from the community...
Hi,
Has anyone converted the Adafruit graphics library for Arduino, Adafruit_GFX.h, to be compatible with the nRF51?
Could you please advise on how to convert this Arduino...
Hi all,
I have a few questions:
How is that ADC's common mode rejection capabilities? Rejection for 60 Hz interference, etc...
The datasheet has "typical...
Hi all !
I'm trying to evaluate the throughput i can have between a Motorola 4G and the nrf51. The nRF51 is the peripheral and the phone is acting as a central.
To do...
I have a digital microphone chip, it has the CLK, DATA, LR_SEL three pins, now I will pick up the three pin nrf5283 three pin is as follows: CLK connectionI2S_CONFIG_SCK_PIN...
Hi,
I am new to Nordic product. I bought nRF52840 board and DWM3000EVB board from Qarvo for building some UWB project. I checked this forum a little bit. But I still did...
Hi,
We are using iBeacon to locate the relative position of mobile phone between two beacons.And the distance between mobile phone and beacons no more than 20m.
Is that...
Hi there,
We are looking for an example application for the nRF5340 DK that runs a very basic baremetal application. All sample applications seems to be using the Zephyr...
I have been working with nrf52 to produce unix time stamp but it using the rtc is a tougher task. Hence, Please help in providing a header file that has a macro such as time_t...
Hello,
I’m using the secure bootloader for serial DFU (UART, not USB). To enter bootloader mode from the application, I write 0xB1 to GPREGRET, then call NVIC_SystemReset...
Hi,
I want to automatically load the value of POUTA_UICR into TX_GAIN at startup. The program code writes the setting value according to the steps on page 14 of the manual...
Hi,Nordic Friends,
I'm using nrf5340dk,and my project need commnunicate with NB-Iot Modem over uart.Now, I found the dirver that i can use directly.But When I configed the...
Hello All,
My company has recently decided to switch to Nordic at the direction of one of our suppliers. We are very impressed with the devices offered and the available...
I use a nRF5280 DK to get DFU working.
I connect to the DFUTarg, Click the Start Secure DFU icon, select my app_v3.zip file, click Start DFU
I get this error during...
Hi there!
I just switched from the GPS Library to the GNSS API.
The problem is, that we never get the timeout event NRF_MODEM_GNSS_EVT_SLEEP_AFTER_TIMEOUT . Basically...
Hi, I took a look at the low power comparator example from the Nordic SDK and test it with my nRF52-DK and I found out that the comparator isn´t triggering when I set the...
Hello, I have a problem with the I2C peripheral on my nrf53840. I enable i2c driver on my project and read sensors on the bus. Everything is OK. Then when with Power management...
