Hi Guys,
I know this is more for software issues. But I was curious as to where I can find trusted case providers/makers for the nrf51822 Beacon. Can anyone from the community...
Hi,
Has anyone converted the Adafruit graphics library for Arduino, Adafruit_GFX.h, to be compatible with the nRF51?
Could you please advise on how to convert this Arduino...
Hi all,
I have a few questions:
How is that ADC's common mode rejection capabilities? Rejection for 60 Hz interference, etc...
The datasheet has "typical...
Hi all !
I'm trying to evaluate the throughput i can have between a Motorola 4G and the nrf51. The nRF51 is the peripheral and the phone is acting as a central.
To do...
I have a digital microphone chip, it has the CLK, DATA, LR_SEL three pins, now I will pick up the three pin nrf5283 three pin is as follows: CLK connectionI2S_CONFIG_SCK_PIN...
I have the same problem as how to discovery 128bit characteristic UUID which is totally different form 128bit service UUID ，the uuid in this question is the same with me,but...
I have added ANCS related functions to my project, but sometimes I get some errors. The error message is as follows: Error: Parameter does not refer to an existing object...
Hi,
I want to change value of serial number after dis init, I want to use sd_ble_gatts_value_set to set the new value, but I dnot know what is the right connection handle...
Hi
I try to flash the firmware from project light_switch_server_nrf52840_xxAA_s140_6_1_0 to nRF52840 dongle to build the Mesh Network with below modifications:-
Use...
I set the Thread network with 2 Dev Kits. I tested it using CLI directly. The network works.
But I can't observe topology on the monitor tool.
Reproduce path:
Follow...
Ive been working on this for some time and can not get two boards successfully communicating using the 125Kbps on the NRF52840. I am simply having one chip transmit advertising...
HI........ I am working on nRF MESH latest version , so i am here using three boards nRF52832 , i have set the character message in client side , when the button 1 is pressed...
Just continue my work on implementing LESC MITM on hear_rate_collector (Please check my development environment settings here as well).
Since sd_api_v6 on pc-ble-driver...
Developing IoT product using a module using Nordic nRF52832 - using their Shockburst protocol
Can ANYONE explain why we would need to be registered with the Bluetooth...
Hi,
I'm trying to make provision for AT command interface in my new nRF9160-SiP based design.
Couple of questions related to that:
1) Which UART (nRF9160-SiP pins) should...
HI,
Im using nRF5_SDK_15.3.0_59ac345 - SDK and two different bootloaders.
The first one is - sd_s140_bootloader_buttonless_with_setting_page_dfu_secure_ble_debug_without_bonds...
Hi,
I notice my dfu bootloader oversized after I merge softblink led feature into the example code. How can I modify the linker_section_placement_macros and the linker_section_placements_segments...
Hello,
Working on MAC. High Sierra.
got a 52840 dongle (but also a thingy and a devkit following the latest conference)
Trying to start at the beginning and build...
Hi,
currently I am trying to figure out how to disable the cryptocell hardware after enabling it, because if I enable it and then enter systemOFF, the system still draws...
Hello,
I am using NRF52840 Preview DK, I am running peripheral/SAADC example on the board, I shorted Channel 0 and GND on the board and I am receiving negative values...
