Hi
We are developing software for the nRF51 with Keil under VirtualBox. Previously we used the PCA10000 dongle with the Master Emulator and MCP without issue. Now, with...
We are using nRF51822 for our products.
We want to know the min value of "Receiver sensitivity" when we use this chip for BLE.
The Datasheet says "Receiver sensitivity...
Dear
The BLE Multi-link example (ble_app_multilink_central and ble_app_multilink_peripheral)
shows how one central device can connect to multiple peripheral devices. ...
In the MCP app, if I have the following service data for an Eddystone beacon:
0x10, // Eddystone-URL type
0x00, // TX power in dBm. This is a signed integer so 0xEE ...
I have the nRF Control Panel Android application. It works fine with several BLE devices, but specifically for the Fitbit Flex, it fails to connect.
I know Fitbit wristbandes...
Hi,
The situation:
I was able to successfully receive known packets from a device running gzp_device_dynamic_pairing, from, the host running the gzp_host_dynamic_pairing...
Hi everyone
nrf51822,softdevice s130 2.0.0
now i used softdevice s130 establish two connection as a central with two s110 peripheral device,at the same time i establish...
Hi team,
My customer is evaluating nRF52810 in their project, and they come up with some questions regarding chip MAC address:
1. They understand that chip MAC address...
Hi,
I am using nRF52840 Preview DK with SDK version 15.3
I want to connect to a peripheral and configure some of its behavior such as Transmission power, Transmission...
Hello! I am using nRF5 SDK 15.3.0. The SPIM sck and the QSPI sck pin is same on my Pcb. When i initialized both peripheral SPIM works well ,but the QSPI not works. Is there...
Hi
I'm currently struggling a bit with the zboss API. I am trying to define 2 lights on my nRF52840 DK board. Via Amazon Alexa, it should be possible to control these two...
Hello,
I'm starting design on a new BLE dongle project.
I am planning to use nRF52840 and an external flash memory for storing sensor data. I need to include timestamp...
Somewhat doubtfully updated to DAPLINK, followed the guide re - turning off services/storage service to get this update to work. All looked good.
but board now appears BRICKED...
Hello everyone,
I want to ask whether the NRF51822 can exit SYSTEM OFF mode with interrupt from a timer?
In the user guide I read:
The system can be woken up from...
Hi,
I have developed a application on nRF51822 that is detect eBeacon and read some information in Beacon and Scan reponse frames.
There is about 200 systems deployed...
Hi, I have been working with the nRF52840-DK and the dongle for some time with OpenThread and it works great. I have now built a mesh application which I want to run on the...
Dear Ladies and Gentlemen
We recently received two Bluetooth 5.0 modules, one nRF52840- and one nRF52832 developmentkit. The aim is to use these two bluetooth devices...
It looks like that 1Mb flash is useful for people like me who don't want to worry about external flash. The question I have is how aggressively I can use the storage? It only...
Hi
i have below requirement:
My device acts as central and i am using db discovery module to discover services which are registered using ble_db_discovery_evt_register...
Hi,
I am tryin to erase the DK board using nRFgo studio, but it not detecting the device.
It get detected in SES studio and programmed also. We reset the baord and...
