Hi all,
I am using ble open mesh with pca10028 boards ble mesh is working fine.
I am developing a application that has to blink led in mesh( without any delay between...
I'm still on stack 8.0.0 so it might have been fixed since. I have noticed that if the other side de-asserts CTS the Nordic code will leave the TX asserted in a Break condition...
Hello,
I'd like to ask what is the data rate when using BLE OpenMesh network and how much it depends on network architecture.
I'm considering using it in a network consisting...
Hello Nordic Community,
I need to know how to import my PCB design from Eagle to CST Studio to simulate it and I need to know if the simulation step will be useful to enhance...
Hi.
I'm trying to get Apple notifications to nrf52. And specifically to listen both regular ANS (for android) and ANCS (for iOS) events depending what sort of phone is...
I am trying to find out the part number of the antenna (I assume it is a PCB antenna) used in the nRF51 DK ( www.nordicsemi.com/.../nRF51-DK) . I found a lot of similar questions...
Hi.
I am using the NRF52 Development board, on Keil uVision, to implement a C program that uses Dynamic Structs. The Structs re-size themselves ( by increasing their capacity...
I am configuring the SAADC for Single-ended mode which I would think is a simple/common task, but my output from the ADC is very jittery. It seems to jump between a good reading...
Hi!
SDK15, s132, SD6.0.0, nRF52832
I have nRF52832 in central mode and some bonded HID devices and another nRF52832 peripherial devices.
Now in the my central nRF52832...
I simulated the balun of nrf51822 accroding to the referenced design of nrf51822 on the official website. However,it showed the differential phase of the balun was not 180...
Hello team,
We are using CPU NRF52832/810. We have followed the THINGY hardware for BLE Antenna with Ceramic Chip. Due to our range requirement more than 100 meter, we wanted...
DK : nRF52840
SDK :15.3.0
example code : nRF5_SDK_15.3.0\examples\peripheral\flash_fstorage
I watched that using nRF52840 DK is best way for develop nRF52811. So I...
Hi,
We have a product that uses nRF52832, we are trying to get the FCC Certification. We are using the RF test example to setup the DUT.
We are able to get the signals...
Hi,
I wanted to use Nordi UART service, the problem is that if I have no contraction with the device, it would not advertise after a definite time, say 180 Seconds, my devices...
I'm trying to connect nRF916 FP1 Preview DK to LTE-M network using LTE Link Monitor but it fails. Below is details about my firmware/software:
Zephyr OS v1.13.99-ncs2
...
Hello,
I am currently working on nRF52840 DK while waiting for my custom board using this chip.
This custom board will include Toshiba external flash of family TC58CYG2S0HxAIx...
Please understand that it is English using a machine.
Hello. I try to create a module using nrf52810 and nrf52840. We are testing "secure_uart_pca10040_s112...
Hi,
the bootloader addr is start form 0x28000, and I checked my application code, it only reached 0x25B00.
I called the fstroge to erased a page Flash start from 0x27000...
