Hi.
I'm trying to get Apple notifications to nrf52. And specifically to listen both regular ANS (for android) and ANCS (for iOS) events depending what sort of phone is...
I am trying to find out the part number of the antenna (I assume it is a PCB antenna) used in the nRF51 DK ( www.nordicsemi.com/.../nRF51-DK) . I found a lot of similar questions...
Hi.
I am using the NRF52 Development board, on Keil uVision, to implement a C program that uses Dynamic Structs. The Structs re-size themselves ( by increasing their capacity...
Hello,
I have an NRF51822 (redbealab ble nano) that I would like to use to count pulses in very low power mode.
Pulses are asynchronous
The rate of pulses can...
Hi
I'm attempting to read a PT-100 sensor value that is part of a voltage divider using a nRF52.
Both the reference resistor and the PT-100 is sampled while the voltage...
Hi
I have been searching the forums, but were not able to find an answer to my question.
I'm trying to sample 4 analog inputs on the nRF51-DK using the ADC hal. (SDK10...
Hi
I have been trying to get two NRF24L01 chips communicate with each other since a week now, without much success. All what I can find on the net is Arduino examples using...
Hello everyone
I started working on BLE devices recently and I have an Ardunio with BLE 4.2. However the maximum data rate seems to be low for my purpose ( about 60 Kbits...
Hi Guys,
I have been trying to port the older nRF51 debouncer_example (attached) into the nRF52 SDK15.2 ble_app_template example with not much luck. I realise that this...
Dear nordic,
1. Is it possible to create thread networking using dongle?
2. I want to create Thread CLI example in dongle but the problem here is UART pins and LEDS. what...
hi ,
I'm a newer , using nRF5_SDK_15.3.0_59ac345. we are using nrf52832 to get about 100 of heart rate sensors.
so first we do a scan ,and get all of there addrs. and...
Hi Dear
We plan to implement our own DFU controller on host MCU, the bootloader+softdevice+app zip file will be generated by nrftutil software.
How to exact those part...
The Capacitive Sensor low-level library documentation says:
Note:
Until Anomaly 84 (ISOURCE not functional) is fixed, the COMP solution cannot provide production-level...
Hi.
I usually used nrf52832 rather than nrf52810 since nrf52832 has an FPU, I rarely considered the computational cost for calculating floating point.
The problem is,...
Just to clarify a bit, I get that the DFU will take ages to propagate though a large network, but the first insertion of the new DFU from, lets say a cellphone, to the "proxy...
Hi, I am using nRF24L01 as a part of a larger project that involves communication between two such transceivers sending and receiving data. I am trying to get a similar but...
Could I get a code sample that shows how to drive gpio pins high on the 52840 chip on my 9160DK so I can modify it to drive analog switches to forward gpio pins to the 9160...
Dear Sir,
I'm investigating the possibility of BLE technology as the primary communication channel for SmartHome Hub solution ( hub to smarthome products... )
I have...
