Hello Nordic Community,
I need to know how to import my PCB design from Eagle to CST Studio to simulate it and I need to know if the simulation step will be useful to enhance...
Hi.
I'm trying to get Apple notifications to nrf52. And specifically to listen both regular ANS (for android) and ANCS (for iOS) events depending what sort of phone is...
I am trying to find out the part number of the antenna (I assume it is a PCB antenna) used in the nRF51 DK ( www.nordicsemi.com/.../nRF51-DK) . I found a lot of similar questions...
Hi.
I am using the NRF52 Development board, on Keil uVision, to implement a C program that uses Dynamic Structs. The Structs re-size themselves ( by increasing their capacity...
Hello,
I have an NRF51822 (redbealab ble nano) that I would like to use to count pulses in very low power mode.
Pulses are asynchronous
The rate of pulses can...
Hi
I'm attempting to read a PT-100 sensor value that is part of a voltage divider using a nRF52.
Both the reference resistor and the PT-100 is sampled while the voltage...
Hi
I have been searching the forums, but were not able to find an answer to my question.
I'm trying to sample 4 analog inputs on the nRF51-DK using the ADC hal. (SDK10...
Hello,
we recently migrated from SDK12.2 to SDK14.2 and noticed a strange behaviour.
After connecting to a bonded device the nrfx_gpiote_irq_handler is no longer called...
Hello,
with SDK15 the definition of the nrf_dfu_flash_callback_t changed from
to
we used the nrf_fstorage_evt_t->result to determine the success of the operation...
Hi,
My application requires a Bluetooth range from 90-100meter. Can you guide me if you have any BLE chipset validated with an RF amplifier using a trace antenna? Can I...
Hi,
we configure a GATT Server with a characteristic that is configuered for write with authorization. If we then try to write one byte to this characteristic from the client...
Hello NORDIC and Tech support members. I am new to NORDIAC devlopment please support me how I start with nordiac please guide step by step and please let me know how I Start...
Hi all,
Where can I find the default program that comes with nRF9160 DK in box?
I'd erased memory and programmed with AT command program but I would want to program as...
Nrf51822QFAAC0 uses softdevic: s110_nrf51822_6.0.0-5.beta, sdk: nrf51_sdk_v5_1_0_36092. Use serial routines. When I annotate the initialization of serial port, and annotate...
Hi,
I have successfully implement the code demonstrated in the two tutorials shown here:
https://devzone.nordicsemi.com/tutorials/b/bluetooth-low-energy/posts/ble-characteristics...
Hi Everyone
As the subject mention，
RTT stops working when power is disturbed by motor.
But other fuction that like ble,spi,uart are work well ，
I must cutoff...
Hi,
I am using NRF52832 with SDK 15.2. In the example, UART/Serial Port Emulation over BLE. The documentation says that this example uses hardware flow control. Therefore...
Hi, I just started nRF52 DK from scratch and downloaded several things informed from infocenter like SEGGER, Keil and SDK, but have no background about these things.
The...
I am trying to understand the provisioning process as defined in the Bluetooth Mesh Profile v1.01 specification. In particular, I don't understand the following paragraph...
