I am trying to find out the part number of the antenna (I assume it is a PCB antenna) used in the nRF51 DK ( www.nordicsemi.com/.../nRF51-DK) . I found a lot of similar questions...
Hi.
I am using the NRF52 Development board, on Keil uVision, to implement a C program that uses Dynamic Structs. The Structs re-size themselves ( by increasing their capacity...
Hello,
I have an NRF51822 (redbealab ble nano) that I would like to use to count pulses in very low power mode.
Pulses are asynchronous
The rate of pulses can...
Hi
I'm attempting to read a PT-100 sensor value that is part of a voltage divider using a nRF52.
Both the reference resistor and the PT-100 is sampled while the voltage...
Hi
I have been searching the forums, but were not able to find an answer to my question.
I'm trying to sample 4 analog inputs on the nRF51-DK using the ADC hal. (SDK10...
Hi
I have been trying to get two NRF24L01 chips communicate with each other since a week now, without much success. All what I can find on the net is Arduino examples using...
Hi
I have done several projects with the nRF905. I know the device quite well. Normally I use the CD, AM and DR interrupt pins to determine the status of the device, my current...
Dear Tech,
I am using the pre release version of the VS Code plugin and NCS v2.7.0 for development. Our team hopes to develop the product based the official version to ensure...
Hello Everyone,
I used the HRS application example for LESC secure communication and added the OTA to the HRS application. After adding that, the device restarts. I debugged...
I am programming now nrf52810 I try to merge uart functionality to ble_app_blinky project but it does not work i debug and found out uar_error_handler() never been reached...
Hi.
I am using a custom board on the nRF52820 microcontroller (wiring diagram in the figure). When the microcontroller is powered only from the battery (via external LDO...
Document: HTTPS_SAMPLE_2024_09_19T02_55_15_089Z.txt I was programming the HTTPS sample with default parameters. I managed to connect to "example.com successfully". I managed...
I'm working on a BLE project based off of the peripheral_lbs sample within the nRF Connect SDK v2.7.0. I am attempting to increase the BLE security level up to either level...
Hi,
I am working on a battery powered device that collects data, save it to files and go to sleep, when it is not connected to a laptop via USB. When connected, the device...
Hi,
I want to change the LED pin that blinks to indicate BLE advertisement to pin 6. I have changed the LED_1 and LED_STOP in pca10040.h to 6:
I have also set NRF_LOG_BACKEND_UART_ENABLED...
Hi.
I am developing a custom board using nRF52840 inside a Moko MK08A and an accelerometer LIS2DH.
My circuit has a 3V3 voltage regulator just for the LIS. The microcontroller...
Hello
I'm trying to connect muy Power Profiler Kit II to my PC, and when I choose the device from the list it pops-up:
I clicked 'Program' and after I supposed it...
Hello,
I'm trying to access active PCO from nrf9160 applicaton to be able to diagnose problems like missing DNS, wrong access point etc. I tried using %XPCO command, AT...
Hello.
I am developing device using nRF52840 and i have question about analog pin usage.
My circuit is analog Pins getting voltage supply while nRF52840 is not used...
Hello Nordic team,
how is it possible to perform Packet Error Rate testing during an active OpenThread connection between two nRF52840 devices? The requested test scenario...
