Hello,
I have an NRF51822 (redbealab ble nano) that I would like to use to count pulses in very low power mode.
Pulses are asynchronous
The rate of pulses can...
Hi
I'm attempting to read a PT-100 sensor value that is part of a voltage divider using a nRF52.
Both the reference resistor and the PT-100 is sampled while the voltage...
Hi
I have been searching the forums, but were not able to find an answer to my question.
I'm trying to sample 4 analog inputs on the nRF51-DK using the ADC hal. (SDK10...
Hi
I have been trying to get two NRF24L01 chips communicate with each other since a week now, without much success. All what I can find on the net is Arduino examples using...
Hi
I have done several projects with the nRF905. I know the device quite well. Normally I use the CD, AM and DR interrupt pins to determine the status of the device, my current...
i made this project to try to create RSC service on arduino
developer.bluetooth.org/.../runningspeedandcadence.zip
unfortunately the server starts but i'm not able to...
Hello,
Could someone give me a hint with the following problem?
I am using two example projects (ble_app_uart_c, ble_app_hrs) to connect a central and a peripheral.
An...
I am trying to store my temp sensor readings in an external flash memory( Winbond W25qXX ).
Can you provide me the respective driver for the same?
BTW I have found driver...
It seems that thread has a function to automatically switch channels when the signal is bad.
Suppose when a device in the same thread network is powered down, and then the...
hello Nordic
i am working with nrf52832, on the Central app_ble_blinky axample (with pwm, saadc, timer, app, timer, uart ), sdk 16.0, s132 v7
when running my code on...
Very surprised to not find this in the Marketplace, but can anyone point me to a great sample Github Action for building NRF52 images. My searches are coming up short or using...
Hello
I would like to transmit gps data to my website in addition to nrf cloud, there is a example or documentation about this that I can take of reference? I am working...
Hi I am New with nrf24l01+ and i made my first project it was working perfect with 2 nrf24l01+ without antenna . After the end of the project i change one of the nrf24l01...
I'm trying the given example < twi_sensor >. I connect nRF52 DK P0.26 to my sensor's SDA, nRF52 DK P0.27 connects to my sensor's SCL. My sensor runs at 400kHz, so I modified...
Hello, I'm new for mesh, have a question about the mesh dfu bootloader.
the source device of the mesh dfu shuld be connected to a host. how to assign the uart pin? is it...
I have to integrate a softdevice into an existing nrf52833 SES project. All the documentation I have found isstarting from any of the examples and using GNU Linker instead...
Hi,
I am trying to create an application for nrf52810 soc. I have a problem on selecting board name and the SDK version
I am having nrf52DK (nRF52832 soc) development...
Folks. I developed my own circuit using nRF 52833 and I`m trying to upload a new firmware via SWD interface. I'm not getting connected to the target for any reason. Is there...
Using SDK 17.0.2 and the nRF52840DK, I am setting up SPIM with a memory IC (not actually hooked up though, just looking at the signals on the oscilloscope). This code is executed...
