I am trying to find out the part number of the antenna (I assume it is a PCB antenna) used in the nRF51 DK ( www.nordicsemi.com/.../nRF51-DK) . I found a lot of similar questions...
Hi.
I am using the NRF52 Development board, on Keil uVision, to implement a C program that uses Dynamic Structs. The Structs re-size themselves ( by increasing their capacity...
Hello,
I have an NRF51822 (redbealab ble nano) that I would like to use to count pulses in very low power mode.
Pulses are asynchronous
The rate of pulses can...
Hi
I'm attempting to read a PT-100 sensor value that is part of a voltage divider using a nRF52.
Both the reference resistor and the PT-100 is sampled while the voltage...
Hi
I have been searching the forums, but were not able to find an answer to my question.
I'm trying to sample 4 analog inputs on the nRF51-DK using the ADC hal. (SDK10...
Hi
I have been trying to get two NRF24L01 chips communicate with each other since a week now, without much success. All what I can find on the net is Arduino examples using...
Hi
I have done several projects with the nRF905. I know the device quite well. Normally I use the CD, AM and DR interrupt pins to determine the status of the device, my current...
Hi everyone, for the project I'm developing it's extremely important to measure RTT as accurately as possible and as such, after some SoftDevice specification I imagined the...
Hi,
I am using Ble_app_gatts central example. Applied filter on name and connection made with some device which is not Nordic BLE device.
As in this central code, after...
Hi All,
I am using Keil and GCC but I want to migrate my projject to "Seggers Embedded Studio for ARM". After following the tutorial about migration, i have been able to...
I've been doing some exercises with the FDS module to ensure I understand it and have come across an issue. When I write I am not seeing a write call-back in the fds_event_handler...
I do not know why the comparator does not compare correctly. I use AIN6 as Vin+; ANI0 as Vin-. The code is show in below. The comparator is work in differential mode.
...
Hello,
I am using the following
Mesh Version : nrf5_SDK_for_Mesh_v2.2.0_src
SDK Version : nRF5_SDK_15.0.0_a53641a
IDE : SEGGER Embedded Studio for ARM Release 4.10...
Just wondering if anyone knows a reliable method to update a project to use a new SOFTDEVICE version?
One that can be repeated for each new release.
I am using Segger...
Hi,
I have a question about pairing a phone with the nrf52832.
During the pairing phase (the phone see our device that is advertising and then starts the paring procedure...
Hello,
i am facing issue with nRF5x Command Line Tools. I am using custom board with nRF52832. While i am using Segger J-flash Lite there is no problem to flash program...
I am developing a wearable using nRF52832 and looking for best debugging practice. I have given provision for SWD pin connection on PCB board. What is the best suitable JLink...
Dear all,
I'm looking if there is a easy way to add custom commands to the OpenThread CLI without touching the OpenThread core ? I didn't find anything in the API.
Thank...
Hi Nordic team,
I having problem understand TWI_INSTANCE_ID and what are usage of this configuration?
For example, if I were to use 2 different TWI hw port (SCL1,SDA1...
I am using a raspberry pi that is running a NUS service. The PacketList in Wireshark shows the advertising packets from the device, but the device is not showing up in the...
