Hello Nordic Community,
I need to know how to import my PCB design from Eagle to CST Studio to simulate it and I need to know if the simulation step will be useful to enhance...
Hi.
I'm trying to get Apple notifications to nrf52. And specifically to listen both regular ANS (for android) and ANCS (for iOS) events depending what sort of phone is...
I am trying to find out the part number of the antenna (I assume it is a PCB antenna) used in the nRF51 DK ( www.nordicsemi.com/.../nRF51-DK) . I found a lot of similar questions...
Hi.
I am using the NRF52 Development board, on Keil uVision, to implement a C program that uses Dynamic Structs. The Structs re-size themselves ( by increasing their capacity...
Hello,
I have an NRF51822 (redbealab ble nano) that I would like to use to count pulses in very low power mode.
Pulses are asynchronous
The rate of pulses can...
Hi
I'm attempting to read a PT-100 sensor value that is part of a voltage divider using a nRF52.
Both the reference resistor and the PT-100 is sampled while the voltage...
Hi
I have been searching the forums, but were not able to find an answer to my question.
I'm trying to sample 4 analog inputs on the nRF51-DK using the ADC hal. (SDK10...
Hello everyone,
I write this post because I haven't been able to find a solution to a problem I'm having to implement a parallel to serial converter. I am employing the...
Hi,
I am using the NRF52840, softdevice: s140, example: ble_app_uart from nRF5_SDK_15.2.0_9412b96.
short description of my application: i am developing an application...
Hi there,
I have been testing with the nrf9160 DK for a while now and I cant figure out how to get the device to sleep properly. I have been working with the asset_tracker...
Hi,
I've installed nRF sniffer version 2-0-0-beta on nRF52832 DK and verified it with BLE Beacon example. It works nice.
But when running light-switch example from Mesh...
Hi Nordic Team
We are working on BLE Modules which includes the chip-set nRF51822 and nRF52832.
We have tight form-factor and want to have longer range communication so...
Hi, I have a problem with waking up a device, description as below.
Application description: I made some application which is based on Serial example - all is working fine...
Hi
What is the default PHY when using NRF52832, SDK 14.2 and SD S132 v5.0?
When does a device's PHY get reset to this default value? Is it upon disconnect or is it as...
Hello,
I'm developing Win32 application, where I have to communicate with BLE device from our customer. At the beginning is simple application level authentication (with...
At the moment I am collecting 64 RSSI values into an array and want to calculate the average and variance of them. I have managed to calculate the average by adding up the...
Hi i am trying to debug the ble Uart app for confuguring device as Central. Which function is responsible for BLE Connection. I unable to debug this code with breakpoints...
I'm using a PCA10040 V1.1.1 dev board (nrf52). I programmed it with "Nordic_HRM" example, but modified it to send 20bytes data at 100Hz.
Then, on my PC, I use a PCA10031...
