I am trying to find out the part number of the antenna (I assume it is a PCB antenna) used in the nRF51 DK ( www.nordicsemi.com/.../nRF51-DK) . I found a lot of similar questions...
Hi.
I am using the NRF52 Development board, on Keil uVision, to implement a C program that uses Dynamic Structs. The Structs re-size themselves ( by increasing their capacity...
Hello,
I have an NRF51822 (redbealab ble nano) that I would like to use to count pulses in very low power mode.
Pulses are asynchronous
The rate of pulses can...
Hi
I'm attempting to read a PT-100 sensor value that is part of a voltage divider using a nRF52.
Both the reference resistor and the PT-100 is sampled while the voltage...
Hi
I have been searching the forums, but were not able to find an answer to my question.
I'm trying to sample 4 analog inputs on the nRF51-DK using the ADC hal. (SDK10...
Hi
I have been trying to get two NRF24L01 chips communicate with each other since a week now, without much success. All what I can find on the net is Arduino examples using...
Hi
I have done several projects with the nRF905. I know the device quite well. Normally I use the CD, AM and DR interrupt pins to determine the status of the device, my current...
hi, i am using nrf52832 and a peripheral device , i had merged two programs uart and twi sensor . its working fine . now i want to get a resolution for my temperature data...
Hi,
I'm trying to read data which transfer from Nordic circuit using an android device. But when I try to call connect() function, it returns an error message saying "Read...
Hi,
I enable nrf51822 deep sleep mode with
and got 0.23uA current consumption instead of 0.6uA expected current consumption. What is happening?
This is the board...
Hello,
I'm having an issue when I try to connect to my device from an iPhone 8. I'm using s132_nrf52_5.0.0_softdevice on SDK 14.2.
The phone tries to connect and then...
Hi ,
I see always No response received on the master control panel for one of my nrf51 dongle pca10031 , Can you please help me how to trouble shoot this isssue .
...
Hi !
A questions to Nordic employees about the GATT Service Changed indications.
We have a peripheral with software based on SDK 12.3. When testing using android as a...
Hi all,
Not being a developer, but having a fair general understanding in IT and computing science, if I wanted to have a first approach but clear idea of all the processes...
we found a device using onsemi rsl10, it can keep ble broadcasting with current below 30uA, and can be connected by mobilephones
we tried to get a similar effect using...
hardware: power profile kit rev 1.1, nrf52840DK
mode: power profiling with DK
I am power profiling my application and found that if there is no current in the system,...
In NRF Mesh Android, when we set the init value for sequence number (SequenceNumber.java), it will check the sequence value stored in SharedPreferences and return 0 if SharedPreferences...
Hi,
as a new year's gift I've noticed s332 v6 is available from ThisIsAnt's download page. I'm developing on nrf52 using SDK v14.2 since it was the latest supported for...
Hi,
I am testing the light switch sample in mesh sdk 2.2, in server part I need to drive an I2C slave device, which may take some time to init, so I put the init code after...
Using SDK 15.
adc_read works properly in main loop.
When called from an APP_Timer or from BLE connect event, function hangs. I set a breakpoint at the handler, and breaks...
