I am trying to find out the part number of the antenna (I assume it is a PCB antenna) used in the nRF51 DK ( www.nordicsemi.com/.../nRF51-DK) . I found a lot of similar questions...
Hi.
I am using the NRF52 Development board, on Keil uVision, to implement a C program that uses Dynamic Structs. The Structs re-size themselves ( by increasing their capacity...
Hello,
I have an NRF51822 (redbealab ble nano) that I would like to use to count pulses in very low power mode.
Pulses are asynchronous
The rate of pulses can...
Hi
I'm attempting to read a PT-100 sensor value that is part of a voltage divider using a nRF52.
Both the reference resistor and the PT-100 is sampled while the voltage...
Hi
I have been searching the forums, but were not able to find an answer to my question.
I'm trying to sample 4 analog inputs on the nRF51-DK using the ADC hal. (SDK10...
Hi
I have been trying to get two NRF24L01 chips communicate with each other since a week now, without much success. All what I can find on the net is Arduino examples using...
Hi
I have done several projects with the nRF905. I know the device quite well. Normally I use the CD, AM and DR interrupt pins to determine the status of the device, my current...
Hi everybody,
I suppose our question is mainly in the title.
ThingyLib version is 1.0.2
https://github.com/NordicSemiconductor/Android-Nordic-Thingy/tree/master/thingylib...
I am trying to send the MPU6050 data using BLE nRF51822. I have used ble_app_uart example modified it to read the data over I2C and send the data over BLE. I can successfuly...
Dear Sir,
We are developing our BT device using the 51822 DV.
Our problem is - the pairing code is preset to 6 digits but our LCD display only be able to show 4 digits,...
Hello everyone,
I am preparing customized board using nRF52840, However, I found that SWDIO and SWDCLK are the only two pins available for programmin g and debugging purpose...
Hi. I tested extended advertising of Bluetooth 5 with examples, ble_app_rscs_c and ble_app_rscs , in SDK 15.2. It works well.
And I added 216 bytes manufacturer's data to...
Hi,
I am doing a job with nRF52832 with keil in initial period. I have two peripherals and connect to nRF52832 via uart, and it runs well. Recently, I migrate the job to...
Hello ,
I have met a problem about the communication between nrf52832 and nrf24le over Gazell. nrf52832 is the device and nrf24le is the host. The problem is that nrf24le...
https://devzone.nordicsemi.com/b/blog/posts/measuring-lithium-battery-voltage-with-nrf52
Following the calculations as so, I have worked out the necessary capacitor values...
Hi,
I am using the command line tool nrfjprog to read the device MAC address using the following command:
nrfjprog --memrd 0x100000A4 --w 8 --n 6
I am connected using...
hello,
I want to use nRFgo studio download hex for NRF52810, but I have a problem as follows:
I do not know how to solve the problem, thank you very much!
best regards...
Hi,
I'm using an application based on the light switch provisioner example (BLE mesh 2.2.0).
I'm wondering if the following is possible:
- Request all provisioned nodes...
