hi:
now.i have a development board(nrfgo motherboard).there is a debug port on the board.i think it can be debugged on the keil.if it can.what driver or others i need.thank...
This is what I got after upgrading my nRF51 dongle firmware.
It always times out.
I didn't somehow got one of my J-Link Lite upgraded, but couldn't repeat the process...
Hi all,
Good day.
Could you please recommend an Android or IOS APP which can connect 8 or more BLE peripherals at the same time.
Thanks & Regards
Jenson
I know that suggested debugger for nRF51xxx is J-Link or openOCD with CMSIS-DAP, but I would like to use BDI3000 debugger, which does support SWD interface and Cortex-M0 processors...
Hello. I am literally looking at the set_hrm_cccd function in Python used to write data. This is for the S130 heart rate collector example. I understand the sd.ble_gattc_write...
Totally new to Python but managed to get things like pyserial setup and I've been able run the ble sniffer. However that is as far as my Python knowledge extends, so I need...
Hello,
we recently migrated from SDK12.2 to SDK14.2 and noticed a strange behaviour.
After connecting to a bonded device the nrfx_gpiote_irq_handler is no longer called...
Hello,
with SDK15 the definition of the nrf_dfu_flash_callback_t changed from
to
we used the nrf_fstorage_evt_t->result to determine the success of the operation...
Hi,
My application requires a Bluetooth range from 90-100meter. Can you guide me if you have any BLE chipset validated with an RF amplifier using a trace antenna? Can I...
Hi,
we configure a GATT Server with a characteristic that is configuered for write with authorization. If we then try to write one byte to this characteristic from the client...
Hello NORDIC and Tech support members. I am new to NORDIAC devlopment please support me how I start with nordiac please guide step by step and please let me know how I Start...
Hi all,
Where can I find the default program that comes with nRF9160 DK in box?
I'd erased memory and programmed with AT command program but I would want to program as...
Nrf51822QFAAC0 uses softdevic: s110_nrf51822_6.0.0-5.beta, sdk: nrf51_sdk_v5_1_0_36092. Use serial routines. When I annotate the initialization of serial port, and annotate...
Hi,
I have successfully implement the code demonstrated in the two tutorials shown here:
https://devzone.nordicsemi.com/tutorials/b/bluetooth-low-energy/posts/ble-characteristics...
Hi Everyone
As the subject mention，
RTT stops working when power is disturbed by motor.
But other fuction that like ble,spi,uart are work well ，
I must cutoff...
Hi,
I am using NRF52832 with SDK 15.2. In the example, UART/Serial Port Emulation over BLE. The documentation says that this example uses hardware flow control. Therefore...
Hi, I just started nRF52 DK from scratch and downloaded several things informed from infocenter like SEGGER, Keil and SDK, but have no background about these things.
The...
I am trying to understand the provisioning process as defined in the Bluetooth Mesh Profile v1.01 specification. In particular, I don't understand the following paragraph...
Some Examples discuss background DFU from application level, but those require bringing in IPv6 stack and TFTP client. Since we are planning to integrate DFU of our device...
