Hello Team,
Could you please share some sample application or procedure to handle power modes (Sleep, Deep Sleep, etc) of the nrf9160.
Please let me know.
Regards, ...
Hello,
I have tried twice to request for SUPL license for getting A-GPS working but it has been denied both of the times. I think first time it got denied due to mismatch...
Hi Nordic Team,
The atomic fifo implementation is based on armv7-M, right now I want to port it into cortex-A processor, I made some changes to get it compiled without...
Hi,
Kit:nrf5340
Can you please tell me if there is any example in nrf connect SDK v1.5.0 related to data transfer concepts.
Is ble controller will be enabled during...
I'm was testing the gsp sample in samples/nrf9160/gps. It runs fine on my nRF9160DK and reports NMEA messages. However, when i ran it on my custom board, it failed in setup_modem...
Another MPSL ASSERT 112, 2195 instance.
I am experiencing it now regularly usually directly
after servicing my first breakpoint after boot, then continuing.
The next...
Hello all,
We are experiencing odd behavior with a custom board which is using the NINA B301 by UBlox. This module contains the NRF52840 SoC inside. Looking through the...
Good morning,
The laboratory ask me to put BLE module in emission channel 0 (2402Mhz) and channel 79 (2480Mhz) with GFSK 1Mbps. And after to be able to put in reception...
I am looking to implement EGU with DPPI, however I can only find two examples in sdk-nrf repo...
- https://github.com/nrfconnect/sdk-nrf/blob/main/samples/tfm/tfm_secure_peripheral...
I've successfully built and run the latest nrfF5340_audio (2.3.0-rc1) application for both headset and gateway and am now trying to add the BT shell. Headset builds and runs...
Hi! We are currently migrating our SD-based SDK code to Zephyr, on nrf52833 boards.
While we have finally been able to get MCUBoot ( CONFIG_BOOTLOADER_MCUBOOT =y ) to run...
Hello Team,
We are testing the DTM mode using DTM app in nrf connnect Desktop.
When does the DTM app shows the changes in GUI ? For eg. When I send a command to sweep...
SDK version: 2.1.3
As far as I can tell from Zephyr's documentation, there is no way to set the noise mode for the adxl362. According to the adxl362's datasheet, there are...
Hello,
To follow the talk we add on this ticket .
How can I configure a custom TX gain with the MPSL library ?
I want to have an output power of 8 dBm on the nRF21540...
Hi all,
I got a board back from one of my students, which kind of broke it.
Initially, the JLink on the board did not reply at all to anything. Therefore, I reflashed...
Hi
I'm using an nRF52840 with Zephyr and nRF Connect SDK v2.1.0.
In our device, we use USB (CDC ACM) as an interface that accepts JSON formatted commands. At the same...
Dear Nordic, Greetings! I would like to know what is your best practice to receive your updates/bug fixes of Nordic hardware, software (soft device, SDK, toolchain, security...
Hi,
I'm pretty lost in the nRF52 SDK V2.2.0. I've managed to get my nRF52840 DK to connect to my existing Zigbee network using the Zigbee Light Bulb example.
Now I'm...