Hi,
I am trying to run nRF24L01+ in default configuration using simple ping-pong examples using RF24 Arduino library.
The problem is that while ping-pong is getting through...
Hi,
I want to send data from one peripheral(nRF51 DK) to multiple Android Phones. This will be a one way connection from the peripheral to the smartphones. I red on the...
I am working on "nRF51_SDK_8.1.0_b6ed55fnnn\examples\ble_central_and_peripheral\experimental
\app_s130_demo\pca10028\s130\arm4" project .
In this project,in which variable...
Or is there any LCD you could suggest that doesn't need that much code? Simple numeric 2rows would be enough. Want to use it with the nRF51-DK to display some measured valued...
I would like to develop my own central device to communicate with the RedBear Arduino shield. The RB device uses a from of UART communications to send data to/from Android...
I was wanting to use a nRF24L01 with a breadboard but its pin-out didn't allow it. A solution then occurred to me based on parts at hand. I wrote it up with instructions and...
Hello. Can I get a literature to the nRF51 series?
I need a full abstraction of the nRF51, like a book or other information, it's structure schematic of build-in modules...
Dear Ladies and Gentleman
Regarding the Bluetooth SIG Qualification the BQC needs a QDID for the Softdevice Controller Subsystem ( from table 2 of the compatibility matrix...
when i debug samples in Zephyr, i can see log through UART when i use "printk" function.
but i find there has "BT_DBG" and "BT_WARN" in code. so what's its using? and where...
i am receiving some packets so i need to send that packet to central device(mobile) if i send 20-20bytes it successfully sending the data to central device(mobile) if its...
Hi, i am new at nordic. I am working with nRF connect sdk. I am trying to run example applications but the code never runs. I have checked with debug and it never goes to...
I'm using NRF Connect SDK 2.1.0 and a 52840DK. In normal (non-bootloader) mode bluetooth initializes fine (bt_enable succeeds). However, when I start using MCUBoot, bt_enable...
We are experiencing connection issues for specific Android & iPhone but not for others (i.e. Samsung Galaxy S9).
Phones with issues
Android Details
Samsung Galaxy...
Dear,
I have 2 kits nRF52-DK and nRF52840-DK. I want to make simple app for sending data from one kit to another. Is it possible to use only the radio without using BLE...
Hello guys, i currently applying the example about MPU9255 following this: GitHub - Martinsbl/nrf5-mpu-examples
i'm using the app_mpu.c, app_mpu.h, mpu9255_register_map...
Hello,
Just starting off with Nordic hardware and have some basic questions, first my setup:
nrf52840-dk development board
nRF Connect v2.1.0 SDK
Setup to use 2...
Hi all,
I'm trying to turn on the increased voltage for the +3 dBm transmit power. I understand that to do that, I need to set the VREQCTRL register, or associated bit in...
I just tried updating nRF Connect for Desktop from v3.11.1 to v3.12.0. I did not see an option to update, so I uninstalled v3.11.1 before I installed v3.12.0.
I notice that...
For reference I am using NCS v2.0 and VSCode with the NCS extension and coding in C++.
Hi, can you help clarify the expected behavior and usage of the MPSL_TIMESLOT_SIGNAL_RADIO...
