In the nrf51 series reference manual section 12.1.9 it states that there is hardware protection that prevents write instructions from being executed and that there is more...
Hello, I have established the connection between two pca10001 boards, one as central and one as peripheral using multilink_central and multilink_peripheral. I have serial...
Hi,my friend,
Now,I use nrf905.Situation is as follows:
I use the NRF PCB circuit of data manual.Nrf905 work, often loss of data.
1.The Product host is to use the stick...
Hi,
I want to use the Blend Micro with more security. I want use a passkey for the Bluetooth connection. For example through the iOS Device.
Is it possible? Static passkey...
How do I receive multiple signals simultaneously at a single receiver (433MHz) with multiple transmitters ?
I am working on a polling system. This one is similar to the audience...
Hello,
I established a connection between my central and peripheral module. Now i want to write characteristic value on peripheral. I tried with sd_ble_gattc_write function...
I am using the NRF24l01 for my products and looking to buy in bulk(100-1000). Now I know where to buy the just the IC but antenna design is a hard point to break right now...
Hi,
Our custom board stops working sometimes.
At this time, when the power is rebooted, it operates normally.
--
Custom board maker is not addressing this issue...
Hi,
SDK 17.1 has 2 example projects (Blinky) that exchange LED and Button state data. As it stands, the Peripheral side contains the LBS server and the Central contains...
Hi, I'm currently trying to send real time analog sensor data to hivemq broker using nrf9160 DK, is it possible to provide source code for this kind of project? I've attached...
Hi,
I am new to nRF Connect and the nrf52840 Dongle and I am a little confused on how to get started.
I followed the getting started a bit, but somehow I suspect this...
Hi,
I have recently updated to V2.1.1 and I can no longer get my BME280 sensor to work.
I am using the standard code from the samples directory,
my overlay file...
I am developing a product using the nRF52840. I am currently running into a difficult problem. I inquired about it 2 years ago, but it has not been resolved.
I need to process...
Hi, on the nRF52820-QDAA I am using pin 5 AIN3 / P0.05 as an GPIO output to drive a LED (active low).
This does not work in the software, when I drive the pin high with...
Hello,
NRF5340, NCS2.0.2, VScode
I designed a headset，MCU is 5340, and a external flash for DSP program.
the external flash connect to DSP and 5340 use SPI;
i can...
Hello,
I was able to build the nRF Desktop sample application on the nRF5340 platform, but when trying to debug, I get the following error:
Here is my build configuration...
Dear ,
I am going to use debug out function on RF5340 DK.
connection is as below: customer board conncet to nRF5340DK.
customer board use nRF52833.
I tried many times...
Hi,
I was just wondering if the nrf52840 Dongle is in some ways inferior to the other development boards in terms of its capabilities?
As I was going through the examples...
Hi,
I am using a nrf528409dk for my application development using nCS. I have various features from which I need to understand how to add some high priority features into...
Hi,
I'm working with the ncs 1.6.1 peripheral_uart example and am looking to increase the size of the data frame to send 240 bytes per data frame.
I have seen several...
I am taking mqqt_simple of NRF9160 as reference for this question,
This is questing regarding, what is recommendation / Philosophy of using MQTT in NRF9160 with other codes...
