How do I receive multiple signals simultaneously at a single receiver (433MHz) with multiple transmitters ?
I am working on a polling system. This one is similar to the audience...
Hello,
I established a connection between my central and peripheral module. Now i want to write characteristic value on peripheral. I tried with sd_ble_gattc_write function...
I am using the NRF24l01 for my products and looking to buy in bulk(100-1000). Now I know where to buy the just the IC but antenna design is a hard point to break right now...
Hi, my friend,
I've been with nrf905. I use a 16-bit CRC check.
But I encountered problems in use:
1.Nrf905 16-bit CRC check format is CRC-16(IBM):X16+X15+X2+1 or other...
I have two custom PCBs, each of which has a microcontroller and an nrf24L01+. Everything related to the transceiver in the designs are complete duplicates (with the exception...
Hello,
I've built a small BLE-device based on the nrf8001.
With my Iphone I can discover this device and I am able to connect to it and listen to notifications of the...
Our pcb is used for gps location data. We have a nrf24L01 nordic chip as the micro process or between the gps module and wireless module (2G). Our engineer needs to capture...
Good day, I would like to confirm the following points regarding the nRF9160 and nRF5340: nRF9160 1. The modem firmware binary is programmed through the SWD and not a UART...
Is there any Kconfig line to set the TX_POWER on the prj.conf file?
Also are the values listed on the below value also valid for the nRF52832 micro.
developer.nordicsemi...
Hey,
I am trying to add DFU support to my application.
In my case, I copied the code from the NRF SDK 15.3 DFU secure_bootloader example for pca10040_ble and included...
Hi ,
few years ago our team has developped a scorer point for tennis based on your nRF24L01P-T (ricever and transmitter). The transmitter is in the player's cuff with a...
Hi there,
We intend to interface nRF52810 with STM32. While there is documentation available
https://infocenter.nordicsemi.com/index.jsp?topic=%2Fcom.nordic.infocenter...
How can I create a new nRF Connect SDK project from a sample using Segger Embedded Studio?
My idea is to get the settings and libraries right, but replace the actual application...
I’m working on code for a custom board which has an nRF9160 SIAA B1 version. I have a couple earlier boards which use the nRF9160 SICA B0 version. On the older boards, I have...
Hi everyone, i have working for a few days trying to implement the fds module, i have followed the "flash_fds" example but i am struggling a lot trying to make this work....
Have flashed github's bluetooth code onto the nrf52840 DK kit and then tried to scan the available devices using android based mobile, in that bluetooth device name is not...
Hi,
I'm developing a star network with one Server and up to 20 Clients (nrf52840 with S140). The Server holds a large configuration blob (>8kB) which needs to be sent to...
using RF5_SDK_15.2.0 and looking at the one of the examples: blinky with freeRTOS:
nRF5_SDK_15.2.0_9412b96\examples\peripheral\blinky_freertos\main.c
I see that in the...
Hi,
Im currently working with a custom PCB using the nRF52832 and soft device s132 with v5.1.0.
Sometimes the BLE stops advertising and becomes undetectable after a connection...
