to me it made sense that EN_AA settings are controlling the receiving pipes if an ACK has to be sent back upon receiving a valid packet.
then i thought that the settings...
I am using BLE_Gateway example defined in nRF51-ble-bcast-mesh to create an rbc_mesh over 2 nRF51422 devices . For now, I am just testing it out on 2 nRF51422; I will set...
Hello,
I see when you import an example from the pack installer ( for example pwm, ble, timer examples ) it arrives with the misc controls --c99 on by default , so I cannot...
Hi,
We're looking for a low-latency 2.4GHz solution (not BLE) and the nRF51822 is oft-quoted as providing low latency, but what are the typical ms figures we could achieve...
Hello all,
in my previous question (Switch between applications (multiple services.h)) I got the advice to merge my two services into one service, including a HID over...
I am trying to create an nRF8001 based application that will broadcast battery levels (pipes broadcast, set), and give out temperature data (pipe indicate - TX_ACK) to connected...
Hi, I have developed a custom board with NRF52840. I'm using the Secure BLE DFU bootloader from SDK15, but I have many troubles because my application has WatchDog enabled...
Hello All,
Right now i am working on nRF52810 custom board. I use segger studio in windows 7. i used nRF52 SDK 15.2.0 .Right now i am trying to pairing for security purpose...
Hi,
I'm using NRF_LOG for debugging. SDK version is 12.3.0.
I want print error code, File name, Line number.
Error code is printed fine but, file name and line number...
Hi,
I was going through the generic_ponoff_messages.h and generic_dtt_messages.h files and I observed that the message opcodes for the messages are same on both models....
As the S112 Bootloader documentation mentions, the nRF52810 does not support updating the (S112) SoftDevice.
In another question " The update-risk preventive method? " it...
Hi,
can we change duty of one channel of an instance of modules\nrfx\drivers\src\nrfx_pwm.c without affecting or introducing any glitches to other channels of that instance...
I am trying to get an SD card working with the NRF52832 chip, starting with the sd card example (SDK 14.2) using the fatfs module.
The SD card I am using is a Kingston 8GB...
Hi I'm using nrf52DK board with SDK 14.02. I wanted to use PWM Library with softdeivce but I'm getting this <error> app: ERROR 3735928559 [Unknown error code] at E:\nRF5_SDK_14...
I have a Raytac module which contains a nrf52810 AT module in it hooked up to a micro via Uart, so i can send and receive AT commands and data. I'm trying to connect to my...
Hi, I have developed one custom application and enabled DFU features in it.
With the help of nRF Toolbox mobile application, I am changing the application code.
Now I...
I just installed the nRF9160 DK but it showed yellow exclamation marks at the CDC and BULK interfaces. I'm using Windows 7. I couldn't find where these drivers are.
Anyone...
How do I use PWM on a GPIO on port 1 on SDK 15.2? The PWM library examples only sends in the pin number and seems to assume port 0. This answer seemed a bit complex and I...
