Hi We have an application where we what to read i2c sensor data over the air to an iPhone. We've taken ble_app_uart_S130 project and grafted in some twi_hardware code. There...
I am interested in the S130 ability to hold 3 central -> peripheral links over BLE, and am looking for some evidence that this has been accomplished with extremely low-power...
I'm trying to implement channel scanning in our nrf24lu1p based USB dongle.
I'm following the specs and basically loop though each channel ;
loop
stop listening
set...
Hi,
I am using the NRF8001 in UART mode and attempting to bond with my android device (Lollipop 5.0 Nexus 6).
i am using the nordic arduino sdk which is found here:...
Hi, I'm using the nRF8001 in an application that requires security so bonds to the remote client/central. My device supports firmware upgrades that may involve new nRF8001...
Hello.
Initially when reading the Gazell documentation I didn't think it'd be a problem but now in Keil seeing this has introduced some doubt whether it's a thing:
...
The program is hanged when I use below code to set Manufacturing specific data (I am using SDK12.0.0 S130) Please comments.
uint16_t DataSize = 14;
uint8_t MfgSpecData...
Hello,
I would like to implement a precise timer which calculates/counts the time in microseconds which I can use for
calculating the time elapsed between parts of the...
Hi!
Does anyone run UARTE with EasyDMA enabled? I don't want to use interrupts and simply copy every received UARTE bytes to global tx_buffer....and pooling with amount...
Hi,
I want to produce a shared secret key between a Smartphone and a NRF52 in order to encrypt data later with AES-128 (example of key sharing: here ).
To do that i need...
Been having a bit of trouble porting our nRF51 project to nRF52 SDK11. It seems to not like using hal_cm4.c from RTX_CM4.lib with FPU. Seems to get stuck on OS_Tick_Handler...
HI，I want to store some data in 51822. These data was store by my program. I know the pstorage.c could store data. When I do DUF the data could be erased by the bootloader...
I am interested in optimising inputs for ADC measurement on an nRF52.
I have seen quite a bit about nRF51 but am unsure if this remains relevant for nRF52?
Hi!
I have an nRF52832 on a custom board. I managed to flash it through JLink and STLinkv2. But suddenly, I wasn't able to communicate to it anymore.
Openocd tells me...
Hi
The new signed DFU in the SDK12.1 comes along with a experimental buttonless DFU. There are a few bugfixes required to make it working, but the nRF Toolbox app didn...
Hi:
Recently, I want to use nRF52 to read or write some data from a flash chip(w25q128bv) by using spi, I've read Manufactures ID correctly, also, I have wrote a register...
Hello!
I need to interact with two J-Link debuggers, connected to the same PC at the same time. I would then read and write data to the devices connected to the debuggers...
Hi team,
iam using sdk 12.1.0 (ble_app_beacon) I want to advertise the battery percentage.Right now iam using the nrf dongle(it doesn't have cell coin battery) and flashing...
I am attempting to build some ptorotype code using SDK 12.2.0 and GCC and I just added calls to the app_schedukler library and to the saadc driver. I added the relevant source...
