I'm was testing the gsp sample in samples/nrf9160/gps. It runs fine on my nRF9160DK and reports NMEA messages. However, when i ran it on my custom board, it failed in setup_modem...
Hi,
I'm attempting to obtain sensor values for a project to be completed less than a week from now and I have not yet started programming so any help would be greatly appreciated...
Hi
I am using nrf52832,SDK version: SDK : RF5_SDK_17.0.2 .
USE CASE:We have two central and one peripheral.We need to control two central with one peripheral(REMOTE...
Hello,
I am facing an issue with SPI when the SoftDevice S132 is enabled and i cannot figure out what the problem is.
The following test works perfectly when SoftDevice...
Hello!
So I can connect, disconnect and write to my applications characteristics via a PyQt5 GUI I threw together. On the python backend, I use Bleak to
search for devices...
Hi, I am developing using nrf52832 and st7735s.
Successfully displayed the lcd screen using the code in \examples\peripheral\gfx
However, when screen clear, text_8print...
Hi,
I followed the tutorial in the DevAcademy nRF Connect SDK Fundamentals where we try to establish an I2C communication. I managed to compile it, but the i2c_write_dt...
Hi,
I am using bl653_dvk board and ibeacon in zephyr
1. As of clearly i can communicate and update data periodically by using zephyr ibeacon
2. Comming to my issue i...
Hi i was wondering how could i send, with a coap response, one's device network name and a, for exaple a temperature value, like this:
<device's network name>: <temperature...
Hi,
I'm using SEGGER Embedded Studio to write code that writes BLE characteristics to flash storage (via FDS) when they're changed. When the device starts up after a reset...
Hiya,
I was recently looking into using libuarte (alongside SD related functionality) and while trying to pump as much data as I could over UART noticed some missing bytes...
Hi,
I am using the nRF9160 with a multi IMSI SIM card in the US. The SIM supports the 3 major cell operators in the US. I have a case where the modem registers to a network...
Hi:
May I ask 2 questions about LLPM's protocol.
1. BLE have 3types : 1M 、2M and BLE coded 。 During the application of LLPM in nRF52xxx chip, which type do you use, and...
Hi everyone,
I use the UARTE to receive data, and I want to clear rx buffer every time, because If not when the buffer will be full , the next data I received will be split...
Hello,
I'm in the process of migrating from arduino to SES IDE(For more practicality and functionality now what I'm trying to achieve is saving time by not having to rewrite...
Does the s140 softdevice use heap? If not, is it safe to set __HEAP_SIZE makefile variable to 0 ?
(as it is stated for s132 softdevice in the following post softdevice...
Hi,
I am currently using the nRf52832 for ble development in our project. Currently we are facing issues with the service changed characteristic in between firmware upgrades...
Hello,
I am working with a sensor that requires i2c(twim) communication with the sensor and was wondering if there are any good i2c examples using the zephyr drivers to...
Hello,
I am new to the nordic family. I am trying to bring up the UART1 in 9160 DK but it's not working. The same code works for UART0 appropriately.
And the code...