Hello
We need to scan for more than 8 devices, so we can't use witelist directly.
We have an idea to use presaved IRK and mac-addresses and use scanning without witelist...
Dear Nordic,
Do we have ready-to-use keyboard driver with scanning/debouncing?
I've not found an example or docs about using KSCAN with gpio-connected keyboard...
Dear Nordic Experts, This one's a tough nut to crack:
The firmware is based on nRF5 SDK for Mesh 5.0.0 with nRF5 SDK 17.0.2 and Softdevice s132 7.3.0. It runs on a nRF52832...
SoC: nRF5340 SDK: nRF Connect SDK 1.9.1
CMAC calculation works fine with SDK 1.7 and SDK 1.8. But it failed with SDK 1.9.1.
psa_mac_sign_setup returns error = PSA_ERROR_NOT_PERMITTED...
I am developing a bicycle powermeter using the XIAO BLE nRF52840 Sense Breakout board with an AD7799 on a dedicated PCB i also made. I use Segger Embedded Studio v5.42a and...
Hello,
I have now one application that runs on two different boards with different device tree. So inside VSC (Visual Studio Code) it Looks like (under nrfConnect)
Under...
I know part 15 talks about bluetooth requirements, could someone tell me precisely where the FCC says bluetooth devices need a 32 MHz external clock source? Thank you
Hello, recently i've been trying to test the nRF9160-DK.
I flashed the program simple MQTT to the board, I changed all the configuration in order to connect to the server...
What will be the best option for a system that requires low latency and high data throughput.
I have a system with a sampling rate of max 1000 sps for eight channels with...
Hello,
I want to use the Bluetooth Low Energy application with nRF52840-Dongle.
As far as I know, I need to burn the dongle with some suitable fw.
1) Where is this...
Hello,
I am using SoftDevice S140 SDK 7.2.0 with IAR environment . Each time I burn a new image I need to clear all my no init parameters. I tried to read the reset reason...
Hi, i do not have CAT-M1 or NB-IoT in my country. I would like to know if there is any solution i could implement to obtain cellular connectivity while using the nRF9160?...
For reference I am using NCS v2.0 and VSCode NCS plugin programming in C++.
I am trying to get the example ESB TX example working from the nordic sample ( link ).
(Notably...
Tagging Ø yving !
Hello everyone and thanks to the Nordic team for a nice day in Stockholm.
Since the single cell tower localisation was very good compared to GPS...
Hello everyone,
I'm using Gateway (serial example) and send packet "Heartbeat Get" to Devices (Light Switch Server Example )to check alive of devices. But when check alive...
What API could be used to send out ZDO Device announce, when router (zr) or end device joins network ?
Is there any sample code could be referenced?
Thanks,
Robert
