Hello
We need to scan for more than 8 devices, so we can't use witelist directly.
We have an idea to use presaved IRK and mac-addresses and use scanning without witelist...
Dear Nordic,
Do we have ready-to-use keyboard driver with scanning/debouncing?
I've not found an example or docs about using KSCAN with gpio-connected keyboard...
Dear Nordic Experts, This one's a tough nut to crack:
The firmware is based on nRF5 SDK for Mesh 5.0.0 with nRF5 SDK 17.0.2 and Softdevice s132 7.3.0. It runs on a nRF52832...
SoC: nRF5340 SDK: nRF Connect SDK 1.9.1
CMAC calculation works fine with SDK 1.7 and SDK 1.8. But it failed with SDK 1.9.1.
psa_mac_sign_setup returns error = PSA_ERROR_NOT_PERMITTED...
Hi All,
We are in evaluation phase of a project where in our battery powered device would use nrF52840 MCU and communicate to the mobile phone over BLE (say about 5x times...
I am working on nrf52832 and sdk11. I want to store my accelerometer and gyroscope data into external memory.Does anyone have code of it? or any one having .c and .h file...
HI, I am using nrf52832 soc and i develop our own module. i need to create a mesh network within the device.
I am using segger embedded studio 3.34 (windows 10) and SDK...
I am new to BLE and want to learn what options and methods I have available to alter the advertisement package. Is it possible to include a floating point value, that could...
I am working on requirement, where if you hold a button for "1 second " it should turn ON LED1 on the DK, likewise when you press button for "5 seconds" it should turn OFF...
I am working on requirement, where if you hold a button for "1 second " it should turn ON LED1 on the DK, likewise when you press button for "5 seconds" it should turn OFF...
Hi,
I am using pca10040 board of nrf52 dk. I am running battery level measurement code on board but whenever I observed values on serial monitor it shows garbage values...
Dear Developers and Members of the Forum
I have an Apple Macbook 6.1 (Late 2009) that has a built in Bluetooth Chip (Broadcom 2.1+EDR) and I want to use Xiaomi Mi Portable...
Hi,
I am trying to develop low power beacon on nrf52.
Which example should I base on?
I am trying example ble_app_blinky on PCA10040, and I am getting close to 1 mA...
Hi,
I have implemented the Master serial DFU code to update application and SD file. I'm following DFU packet send sequence. Ping, inti packet, FW packet.
I'm framing...
Hi,
I need to develop code for the custom board test, in which I need to enter the <channel> and it <power> value & then begin start/stop the continuous transmit the radio...
Hello,
Recently I purchased a nrf52840 Dongle to use it with nrfConnect for Windows.
I use nrfConnect 2.6.1. When I insert my Dongle in a USB port the LED starts pulsating...
Dear Sir,
We need a sample code for UARTE nRF52832 using EasyDMA. This sample code should drive our UARTE port using in BLE to UART mode. We could not find it by asking...
Hello, i am working with the nRF5 Mesh SDK on nRF52 based boards. Starting from the light_switch example i created a custom model to perform light control and other tasks;...
I cannot set the location in my Profile, this is required for private tickets. When I type anything, I get a window with pulsing elipses, and nothing pops up. I've tried my...
