Hi We have an application where we what to read i2c sensor data over the air to an iPhone. We've taken ble_app_uart_S130 project and grafted in some twi_hardware code. There...
I am interested in the S130 ability to hold 3 central -> peripheral links over BLE, and am looking for some evidence that this has been accomplished with extremely low-power...
I'm trying to implement channel scanning in our nrf24lu1p based USB dongle.
I'm following the specs and basically loop though each channel ;
loop
stop listening
set...
Hi,
I am using the NRF8001 in UART mode and attempting to bond with my android device (Lollipop 5.0 Nexus 6).
i am using the nordic arduino sdk which is found here:...
Hi, I'm using the nRF8001 in an application that requires security so bonds to the remote client/central. My device supports firmware upgrades that may involve new nRF8001...
Hello.
Initially when reading the Gazell documentation I didn't think it'd be a problem but now in Keil seeing this has introduced some doubt whether it's a thing:
...
Hello,
We're using the UDP/IP/6LoWPAN layers as provided by the nRF5 SDK 15.0.0.0.
After experiencing sporadic issues in communication we have a question regarding the...
Hi,
I am using BLE_Blinky_Peripheral example from SDK 15.3.0 with s112 softdevice. I want to use basic softdevice APIs instead of nrf_sdh libraries for enabling BLE stack...
I am a beginner trying to get a device to operate optimally under a battery. Where can I find a starter code template that would shutdown/disable everything, putting the device...
Hi there,
I am working with the NRF52840 Dongle and have been trying to verify what sort of influence other processes on the chip could have on the radio. Specifically,...
Hello Nordic team,
I'm having some trouble with discovering the characteristics of a custom device.
The peripheral device has a private service with UUID 06000002-0000...
I'm busy implementing a (serial) DFU host, but sofar i'm unable to send a proper init packet.
The bootloader keeps returning an invalid signature error
If i open a .dat...
I am using nrf52840dk
sdk15.3.0 and s140
I want to read a sensor data over uart and then advertise it but the advertising never starts after reading over uart even though...
IDE: Segger Embedded Studio
SDK: 15.2
Mesh SDK: 3.1.0
Im working on adding light lightness model to the mesh SDK and it requires doing an equation like sqrt(x * 65535...
Hi all,
I am working on a ble_app_uart sdk example thereby I can connect the bluetooth of nRf52840 to My mobile. I want to read the temperature and send it to my Mobile...
Hi, I am attempting to set up a nRF52840 DK as a BLE peripheral, and have been following the basic setup instructions at infocenter.nordicsemi.com/index.jsp . However, when...
Hallo everybody,
I successfully implemented on the NUS example the Pairing with the Passkey with the following Peer Manager configuration without LESC.
and the BLE...
I've written a DFU client in python. I'm trying to add the ability to restart a failed DFU without having to resend the whole file. I can see that the init packet is saved...
I cannot find an example project for using the PDM module on SDK 15.3.0. Can you please direct me to where I will be able to find such an example project?
Thank you.
HI,
i am using nrf52840.i am sending 500bytes from peripheral to central with the time interval of 100 millisecs. for 5 minutes its working fine,but after 5 minutes the...
