Hello,
I established a connection between my central and peripheral module. Now i want to write characteristic value on peripheral. I tried with sd_ble_gattc_write function...
I am using the NRF24l01 for my products and looking to buy in bulk(100-1000). Now I know where to buy the just the IC but antenna design is a hard point to break right now...
Hi, my friend,
I've been with nrf905. I use a 16-bit CRC check.
But I encountered problems in use:
1.Nrf905 16-bit CRC check format is CRC-16(IBM):X16+X15+X2+1 or other...
I have two custom PCBs, each of which has a microcontroller and an nrf24L01+. Everything related to the transceiver in the designs are complete duplicates (with the exception...
Hello,
I've built a small BLE-device based on the nrf8001.
With my Iphone I can discover this device and I am able to connect to it and listen to notifications of the...
Our pcb is used for gps location data. We have a nrf24L01 nordic chip as the micro process or between the gps module and wireless module (2G). Our engineer needs to capture...
Hey folks,
I'm trying to modify the SPI Master loop back example into a 4 line SPI Master_Slave program. Whenever I change the Tx_Buffer_lenght from 10 to lsome other numbers...
Hi,
I´m looking for a Bluetooth low energy proximity sensor with this (or similar) characterisics:
One main (receiver) module and many secondary (transmitter)...
I'm using a custom board based on the Thingy52 board and firmware that uses the BMD-350 module containing the nRF52832.. I'd like to use the internal RC oscillator for the...
Hi,
I just found out that the scanning procedure does not time out in SDK 15. This is because in SDK 15 we are forced to restart the scanning procedure everytime an advertisement...
I am using nRF5 SDK for Thread and Zigbee 2.0.0
I am having trouble commissioning using NFC, either with the nfc_meshcop example or my own code (based on the nfc_meshcop...
Hi we are trying to test the serial boot loader example from sdk 11,sdk 12.03 non of them working while running using nrf go studio it says enter in dfu mode and while we...
Hi, I want to use the p0.18 as a GPIO without being connected to nRESET function. So I removed "CONFIG_GPIO_AS_PINRESET" from the define option in Keil. And then i found that...
Hi there,
due to unknown reasons, my nrf52840-DK (1.0.0) didn't come back up after flashing software to it. Means the LED that usually turns on when you power it up remains...
Hello All,
I am having issues compiling the "light_switch_client_nrf52840_xxAA_s140_6.1.0" and "light_switch_server_nrf52840_xxAA_s140_6.1.0" example found in the Mesh...
Hi All,
I'm new to nRF52.
I'm working on nRF52 PCA10040 board. How want to how the secure bootloader works?
I tried to load application from DFU serial bootloader and...
I'm trying to use the sample application "\ ble_central \ ble_app_rscs_c".
If I change the NRF_SDH_BLE_CENTRAL_LINK_COUNT file from 1 to 2 in the sdk_config.h file, the...
Hi,
I am new to openthread development. My goal is to distribute measured values received from the SPI Bus over a thread network. I am using a nRF52840-DK Board, SDK for...