Hi,
I'm trying to program nRF51822 Beacon Kit using nRF51DK. I'm trying to load the example ble_app_beacon to the beacon kit. After uploading SoftDevice 7.1.0, I try to...
Hello
I'm using the nRF51 DK and I have a UART over BLE link set up between the board and a phone with the nRF UART app. I'm trying to get the board to execute a particular...
Hello there guys i been reading your 100 pg PDF for awhile now and im yet to understand or realize how is it that i add/place/create a payload or data to send/Tx via Master...
I am interested in writing a BLE central that reads data from multiple BLE Nordic sensors. The BLE central will be running on Embedded Linux which uses the BlueZ stack.
...
Hi,
I'm trying to get S110 softdevice (v8.0.0) working with RIOT. I had some issues (I couldn't initialize TIMER1 or TIMER2 until softdevice is setup & enabled) but I think...
Hello everyone,
I got a task which I try to implement using a NRF51822 iBeacon board.
The Task:
Advertise a Device and provide a mechanism to connect without traditional...
Hello, I'm working with the EK PCA10003, that has the NRF51422. I'm trying to read the information of the accelerometer MPU6000 with an ISP interface. At the moment I cannot...
In Short: How to get status wether noticiations are enabled or not? Where is this stored?
Hello,
I would like my peripheral to start/stop a timer that does measurements...
I have a project which will send the temperature from the nRF51DK to host.
The value of the temperature is an integer. As example Value:0x00000A2B -> 2603 ->26.03°C
...
NRF24L01 has its own protocol, but I do not understand the protocol itself is how to handle the payload sent and appear in the header contains the same Bite, whether to adopt...
I'm implmenting my own radio porotcol and I'm a little confuse on how to handle the ACK packet. I send a packet from node 1 and disable the TX then I enable the RX to get...
I'm unable to pair my device with Windows 8.1.
Pairing with Android works just fine whereas when I try to do it on my computer it just tells me that the device is no longer...
Hi,
I don't know if it is the appropriate place to ask my question.
One of our J-link lite cortexM debuggers is broken. We want to buy a new one. But, we realized that the...
I'm using the 8.0 SDK and an iPad with iOS8.3. I'm experiencing the same issue described here:
pairing cancel cause reset
I've written my own service, however, I can...
Hello,
I noticed the various examples as well as the ble_advertising component all check for pending flash operations and will not start advertising until they are all...
Hi,
I am busy writing my own softdevice, this has nothing to do with bleutooth or anything like this.
In the past i didn't have to worry about the CLENR0 register because...
Hi everybody,
I have a mistake with my makefile on windows 7 platform and Eclipse C edition.
The error is quite rapid =>
20:42:38 **** Build of configuration Default...
Hello devzone...
My setup: nRF51422 and S110 peripheral
My setup transmits IR data on reception of Bluetooth data from a central device. I have used PWM for generating IR...
Does the nRF51422 ANT Inclusion/Exclusion list require all values in the list to be defined, or may some of them be '0' or 'wildcard' values?
Asked in another way, does...
