After ping through link local address ,i am not getting any Router solicitation messages,neighbor solicitation messages and neighbor advertisement messages while i am capturing...
Hi I've got my nRF8001 breakout board ready I now need the SDK in order to start developing firmware code.
I don't have any registration key, how do I get hold of it? ...
Hi,
I'm running Mac OS X 10.10.2 with the nRF51-DK PCA10028 card that I received today. I started off following the instructions in this article , and was able to get JLinkExe...
Hello,
I would like to do an communication between Arduino and Android platform.
In my case, Android will be master.
But I want also test between 2 Arduino with an Bluetooth...
Hello,
I would like to develop a custom key sharing algorithm for nRF8001 chips. As far as I have understood the only way to use full 128-bit temporary key (TK) is OOB...
Hi,
I have been trying to install nRF Connect SDK.
I initially tried installing via the Toolchain Manager as recommended. I have previously used Power Profiler and LTE...
Hello! I've run into a problem after updating much of the environment (cmake, ninja, python, git, etc.) that I can't compile the code in nRF Connect SDK now.
Initially I...
Hello,
I am trying to create two notification characteristics between the nRF52840 and Android app. Though I am able to enable notifications for both the characteristics...
Hello,
after several problems resolved we were quite confident, that the migration to SDK15.3 was successfully completed, but when testing intensively we found a hopefully...
Hi there
I am currently developing a custom wireless protocol for the nRF52805. To do this I am programming the Radio registers directly. In other words, I am not using...
I receive error
I have custom board with nrf52811
my defines in .vscode/c_cpp_properties.json
and my custom MakeFile
I use nRF5_SDK_17.1.0_ddde560 , ARM GCC...
I'm trying to flash the Bootloader sample to my nRF52840 (in order to understand how dfu and ota works).
First I connected the usb cable to the board (at the top of the...
Hello, I am trying to run SPI Slave on NCS with NRFX drivers and for some reason device resets and I cannot figure out why. The code is pretty much straightforward, maybe...
nRF52840 NCS SDK v1.9.1 nRF52840DK
My application is based on the coap_client sample, and is running on the nRF52840DK. It runs fine all alone. I have added code to download...
I want to optimize/ test the power usage of the network search after a network has been lost. I want to try different %PERIODICSEARCHCONF configurations, and measure the required...
Extremely slow scrolling speed. Sometimes taking up to 20s to show current voltages. Unusable. Already downgraded down to version 2.6 of nrfConnect and it still the same....
Hi All. In my final project (Electrical engineering) I'm trying to create a Closed area navigation system using AoA/AoD methods. (e.g., https://www.youtube.com/watch?v=zg9IBP3WRCU...
nRF52804 SPIM3 not work. (SCLK/MOSI not output)
However, if I debug it using jlink, it works.
My environment is nRF52840-DK(PCA10056/v1.0.0) nRF52 SDK 17.0.2
My program...
