But now I have a new problem that is whenever I set " PWR_UP " bit in CONFIG register then it drop the 3.3 volt vcc to 1.2 volt. I don't know why its happening. Anyway, is...
This previous question about multiple advertisements seems to be related to softdevice 7. I was unable to get a similar example working in SD/SDK8
My end-goal is to add...
We are considering using Gazell for an outdoor application, i.e. lots of noise and disturbances, constantly changing environment, where the amount data being transferred is...
Hi everyone,
I have found your git "Ble Optiboot"( github.com/.../ble-optiboot) , and I have understood, it is usefull to load a binary into MCU flash, I was looking for...
I'll go ahead and describe what I need to do and see if anyone might have some place to start for me since I'm having a lot of trouble figuring out what I need.
I'm looking...
We use nRF9160 on our own board with SDK 1.9.1. The firmware "Serial lte modem" is installed on the chip with connection to an external MCU. We are connecting to an MQTT broker...
Hi everyone,
i'm currently developing on nRF9160DK with AWS brocker via NB-IOT connection and i don't know if i'm encountering an issue.
Until now, every time that i reboot...
sdk nRF5_SDK_17.0.2_d674dde
I used some flash to store data.
But before dfu,it was equal to (FF FF FF FF FF FF FF FF|........) and after dfu,it was equal to (29 48 0C...
Hi,
In a multi-role central-peripheral code for a nRF52840-DK based device, I have to send a buffer acting as a peripheral. I use the ble_nus_data_send function sent as...
Hi all,
I am currently trying to realize a USB to Uart bridge with the nRF52840 development kit.
I used an old sample as a starting point for this task namely the " usb...
Hi,
I need a sample project for upgradable mcuboot, I am to understand that to have mcuboot upgradable, I need to have 2 stage boot loader, wherein 1st stage bootloader...
It's mentioned in this forum that MQTT-SN may be implemented on nRF connect SDK. I would kindly ask if there is anything available about that? And will MQTT-SN be officially...
Hi,
I'm using SDK 14.2.0, and nRF52840-Preview-DK.
Followed the tutorial:
devzone.nordicsemi.com/.../
I've programmed the soft device from: ..\components\softdevice...
Hi, I want to use filtered list during BLE advertisement in out project. The flow is as follows: (I'm using nRF connect app for testing ble connection) 1. Just advertise so...
Hello,
We are trying to connect to an AWS MQTT broker using the nRF9160 with modem firmware version 1.2.3 and are not having any luck.
Project background:
Using...
Hi Team,
Setup:
Application: smp_svr with overlay-cdc.conf
Board: nrf52840dongle_nrf52840
NCS: 1.7.0
System: Windows
Tool: mcumgr
I am trying to upload an...
Hi, I have a firmware that runs well on nRF52833 dev kit (SDK 17.02) and I am trying to port it to a BL653 dev kit. The firmware has a bootloader and it can perform DFU over...
Hello，I am using nrf24l01+ product for FCC certification, it requires a modulated carrier. If I send this modulated carrier in the form of data packets, it is not a continuous...
