Hello,
I would like to develop a custom key sharing algorithm for nRF8001 chips. As far as I have understood the only way to use full 128-bit temporary key (TK) is OOB...
i am useing nRF51822 pairing with nRF24lu1 over GZLL protocol now,
is there someone have the experience on how to config the parameter of GZP_TX_RX_TRANS_DELAY in function...
I have a peripheral running the S110 stack, which presents a characteristic to which I want the central (running S120) to be able to do a long write. What I've been trying...
Hi all,
I have been trying to combine the UART and hID Keyboard examples into a single application.
I want to use the HID part to send specific keystrokes using buttons...
Hi, I'm new to BLE and just started feasibility testing, using RF8001, on a small device with no IO. The device will have a unique code set at factory, and printed on label...
I had the same experience as fishman and I went back to give Eclipse a try. (Post: nRF Beacon does not build on Android studio) I tried to build it in Eclipse Luna with the...
Our hardware designed with nRF52840 and npm1300 works perfectly.
We are working on an architecture where a single central communicates with four peripherals...
Hi,
I'm trying to use the periodic sync sample app using 2 nrf52833DK (one for advertising and one for receiving sync) and been getting this assert message every time a...
We use nRF52832 to develop our sensor.
Then SDK version we used is 14.2.0, and the softdevice is S332(ANT_s332_nrf52_2.0.1)
Now we develop the FW hex file with softdevice...
Hi,
When using the NFC record example, bringing an Android phone close to the NFC tag automatically pops up and displays the text content, but an iOS phone does not automatically...
Hi I am currently using NORA-B106 based on nrf5340 to work on ble multilink things. For right now I can do multiple connections by adding several scanning filters. But I cannot...
Hi All,
I'm trying to fully disable all location services with the asset tracker in v2.6.1 while using lwm2m (so I have the lwm2m overlay enabled in the build settings)...
Hi,
I'm stuck in the Cellular IoT Fundamentals course on lesson 2, exercise 2. When adding build configuration I get the following error:
[31/167] Building C object secure_fw...
I would like to integrate the PPK into an automated test system. Are Python drivers available to query the PPK directly for current readings, power control, etc.
I'm trying to test minimum timing and performance using peripheral and central ISO under Zephyr.
I'm trying to play with the interval and latency values under the central...
When I try to debug a programm (build with "optimize for debugging" and debugging started by pressing "Debug" in VSCode) I get to the debug-view and can also go one or a few...
We are working on a custom board (gateway BIS) with the nrf5340. Currently our system is on the 2.5.2 SDK and we currently have FOTA working with an external QSPI flash and...
psa/client.h describes and defines PSA_MAX_IOVEC as follows: Just to be sure: This means that psa_call can only pass 4 input- and output vectors in a psa_call(), or? (E.g...
In the application I try to run the non-secure world mainly just calls functions/services in a custom partition in the secure world, which has more own code and also extensively...
We have started using nPM1300, but now we are unsure how to proceed.
Through our inquiries, we have learned that development requires the use of the ncs platform. However...
